Proxxontools.Com 90 80 70 60 50 40 30 20 10 0 10 20 30 40 50 60 70 80 90 ma x. Z ust ellu ng mm brei te buc he erle pappel bal sa 20 0,5 0,8 0,8 0,8 40 0,3 0,6 0,8 0,8 60 0,2 0,2 0,3 0,8 80 0,1 0,1 0,2 0,6 u = 230 v~ 50/60 hz p = 200 w kb 15 n mess erw elle = 6 .000/ min brei te ma x = 8 0 mm mt 300...
- 3 - 90 80 70 60 50 40 30 20 10 0 10 20 30 40 50 60 70 80 90 4 7 3 9 1 5 13 2 12 fig 1 ma x. Z ust ellu ng mm brei te buc he erle pappel bal sa 20 0,5 0,8 0,8 0,8 40 0,3 0,6 0,8 0,8 60 0,2 0,2 0,3 0,8 80 0,1 0,1 0,2 0,6 u = 230 v~ 50/60 hz p = 200 w kb 15 n mess erw elle = 6 .00 0/m in brei te ma x...
- 4 - operating instructions mt 300 instructions for the use of the micro shaper mt 300: dear customer, in order to be able to operate the shaper safely and correctly, please carefully read the following safety and operating instructions prior to use. This instruction manual covers: • safety regulat...
- 5 - 19. Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function – check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, a...
- 6 - description of the machine the mt 300 table milling machine is ideal for shaping, grooving, chamfering, edging and taking out. With the milling cutter running at 30,000 rpm, clean and precise results with rapid waste removal are guaranteed. The cutter height can be adjusted for a wide range of...
- 7 - proceed as follows: note! For this purpose, it is necessary to remove the cutter shield (fig. 1, item 7). In this case, loosen the knurled screw, 8, (fig. 1) and lift off the shield. When re- mounting the shield, ensure that the hexagonal tip on the shield engages correctly with the hexagonal ...
