1. DL manuals
  2. Proxxon
  3. Power Screwdriver
  4. MIS 1
  5. Operating Manual

Proxxon MIS 1 Operating Manual

Manual is about: MICRO SCREWDRIVER

Summary of MIS 1

  • Page 1

    Proxxontools.Com manual mis 1 - 2 - your device does not work properly? Please read the operating instructions again carefully. If the unit is in fact defective, please send it to: prox-tech, inc. 2555 tate blvd se po box 1909 hickory, nc 28603-1909 we will respond in a prompt and reliable manner. Y...

  • Page 2

    - 3 - foreword dear customer, before putting the machine into operation, read the enclosed safety rules and operating instructions! This manual comprises: foreword . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 general safety rules . . . . . . . . . . . . . . . . . . . . . ...

  • Page 3

    - 3 - foreword dear customer, before putting the machine into operation, read the enclosed safety rules and operating instructions! This manual comprises: foreword . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 general safety rules . . . . . . . . . . . . . . . . . . . . . ...

  • Page 4

    - 5 - avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have the switch on invites accidents. Remove adjusting keys or wrenches before turning the tool on. A wrench or a key that is left attached to a rotating...

  • Page 5

    - 6 - small particles and tiny wire fragments may be discharged at high velocity during the "cleaning" action with these brushes and may become embedded in your skin. Bristles or wires will be discharged from the brush at high speeds. Carefully handle both the tool and individual grinding wheels to ...

  • Page 6

    - 7 - technical data voltage: 12 to 18 v power consumption: 40 watt speed: 150 rpm gear ration 93:1 friction clutch 5-step, 0, 25 to1, 0 nm noise: ≤ 70 db (a) torque with the friction clutch switched off (step 6) 2 nm weight: 400g recommended accessories the machine should be used with the supplied ...