PS Audio Analog HCPS Operating Instructions - page 4
The only active element on the front panel is
the blue PS logo.
The PS logo will illuminate only after the
PCA-2 is connected, has finished its startup
cycle and is powered on.
The logo intensity is controlled by the PCA-
2. The brightness of the logo can be set to
high, low or off by using the DIM button on
the remote of the PCA-2.
5
The power switch will illuminate when there
is power supplied to the unit and the switch
is set to on. The [I] position indicates ON.
The [O] position indicates OFF.
2. Fuse
Note: Unplug the power cord before
checking the fuse.
The fuse is a 3 Amp fast blow. It can be
removed by inserting a flat device into the
fuse holder and twisting counter-clockwise.
3. IEC Power Inlet
15 amp male IEC standard power socket.
4. Preamp Power Supply A
The gray socket provides power to the
control circuitry of the preamplifier. Connect
only the supplied cable with the grey Neutrik
connector to the gray socket.
5. Preamp Power Supply B
The black socket provides power to the ana-
log gain stage of the preamplifier. Connect
only the supplied cable with the black
Neutrik connector to the black socket.
6. Accessory Power Supply
The Accessory socket provides power to
additional PS Audio accessories which are
designed to be powered by the Analog
HCPS. Connect only products which are
specified to work in conjunction with the
Analog HCPS.
Front Panel Layout
4
Rear Panel Layout