PS Audio HCA-2 Operating Instructions Manual

Other manuals for HCA-2: Brochure
Manual is about: PS Audio Classic 250: Brochure

Summary of HCA-2

  • Page 1

    Table of contents 1. Package contents 2. Warning 2. Safety instructions 2. Overview 3. Features 3. Setup guide 4. Back panel 5. Front panel controls 5. Alternate connectivity 5. Using the 12 volt input trigger 6. Using the ps bus 6. Troubleshooting guide 7. Specifications 7. Warranty and service 8. ...

  • Page 2

    Warning to prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the enclosure. Refer servicing to qualified personnel only. To prevent electric shock, use a 3 prong, grounded power cable. Any change or modifications not expressly approved i...

  • Page 3

    Features • stereo power amplifier • 150 watts per channel into 8Ω • 225 watts per channel into 4Ω • sdat™ output stage • balanced jfet input stage • single ended (rca) and balanced (xlr) type inputs • fully balanced internal architecture • internal high current ultimate outlet™ provides ac filtratio...

  • Page 4

    1. 12 volt trigger the hca-2 is equipped with a 12 volt dc input trigger. The 12 volt trigger can be used with other 12 volt trigger equipped products to relay power status. See “using the 12 volt input trigger” for more information. 5. Fuse the fuse is a 7 amp slow blow. It can be removed by insert...

  • Page 5

    Front panel controls power the front panel of the hca-2 was designed to bring both a level of elegance and simplicity into your system. The power button (on/off) is located on the far left-hand side. When the hca-2 is off, pressing this button will initiate the power up sequence. Display the front p...

  • Page 6

    Using the ps bus the ps bus allows for more sophisticated communication between other ps audio products. The hca-2 includes two ps bus connectors. This allows for several ps products to be linked together so they work as a system. There are 4 small switches next to the ps bus connectors. If the ps b...

  • Page 7

    Specifications power rating (both channels, stereo) 8 ohms - 150 watts per channel 4 ohms - 250 watts per channel 2 ohms - 275 watts per channel performance frequency - 20 hz to 20 khz response +/- 0.5 db thd+n - 0.2% @ 1khz (full power) voltage gain - 24 db input impedance - 100k general weight - 3...

  • Page 8

    Ps audio international, inc. 4824 sterling dr. Boulder, co 80301 usa toll free: 877-772-8340 ph: 720-406-8946 fax: 720-406-8967 www.Psaudio.Com.