PS Audio PerfectWave Power Plant 10 Owner's Reference Manual - page 13
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
Quick Start Guide 9
®
Quick Start Guide
©2010 PS Audio International Inc. All rights reserved.
Owner’s Reference
PerfectWave Power Plant 10
output) the breaker will trip and the unit will shut down. Please reduce the load connected to
the P10 by removing high-current-draw components thereby bringing the unit’s wattage output
within acceptable range, reset the circuit breaker by pressing the white button, and power on your
PerfectWave P10. 240V units employ a 10 amp circuit breaker, whereas 120V units employ a 15
amp circuit breaker.
Trigger: As described in QUICK START GUIDE, section: Trigger and IR Commands, these are
the input and output connectors which accept the 3.5mm tip-sleeve connector for 12-Volt Trigger
operations as well as IR controls.
SD Card: An SD card was included with your Power Plant 10, and on the back of the unit there is
a slot into which one can feed this SD card. It does not need to be inserted for the Power Plant
10 to offer top performance, but will be necessary in the event of a firmware update should a
network connection be unavailable.
CATV: There are three pairs of RF connections (units marked UK, GR, and AU do not have CATV
connectors) on the back-panel of the Power Plant 10. Each pair consists of one input and one
output. One can connect a digital feed through these connectors and achieve power protection
for those devices.
Viewing Fundamental System Setup Parameters
Different from the General Setup features which can be accessed by selecting the Setup button
from the HOME SCREEN, this section identifies and instructs on primary usage settings as
described below.
To enter the SYSTEM SETUP SCREEN one must first power down the PerfectWave P10 using
the back-panel power switch. One must then reapply AC power to the PerfectWave P10 be
flipping the back-panel power switch to the “On” position. The unit will initialize for 15 to 20
seconds. After 5 seconds of initialization (see picture),
The P10’s touch-screen will activate.
After its activation, but before the P10
fully initializes and enters the HOME
SCREEN, the unit’s front-panel touch-
screen can be touched anywhere on
its face. This will bring the user to the
SYSTEM SETUP SCREEN where the
following parameters are displayed:
1.
Unit ID
2.
Bootloader
3.
Firmware
4.
Power Meter
5.
Oscillator
Information
Screen