PS Audio Quintet and Duet Power Center Owner's Reference Manual - page 10
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.pspower.com
Troubleshooting 6
Troubleshooting
©2007 PS Audio International Inc. All rights reserved.
Owner’s Reference
Quintet and Duet Power Center
®
If no power comes out of the Power
Center, check to make sure power
is going into the Power Center. You
can do this by testing the outlet it is
plugged into with another device such
as a lamp. Sometimes, we fi nd Power
Centers plugged into switched wall
outlets. These are typically the lower
of the two AC receptacles and are
controlled by a light switch. If you have
no power to the receptacle, check the
circuit breaker feeding the receptacle.
If you have verifi ed there is power to
feed the Power Center, check the
Power Center’s blue PS logo to see if
it is lit. If not, press the logo itself. This
is the power button. Check and make
sure there are no connections to the
triggers. Pull them out if there are. If
the logo does not light, check the circuit breaker next to the AC inlet on the Power Center. Press the
circuit breaker to activate.
Lastly, make sure you are feeding the Power Center the correct voltage. The Power Centers are
specifi c to your country’s voltage. If, for example, you are trying to operate at 120 volt Power Center
on 220 volts, it will not turn on. If all else fails, contact your PS dealer, distributor or PS directly for
help.
If the blue logo power button blinks when you fi rst plug in the Power Center to an AC receptacle, this
is normal. The unit is calculating the voltage
being fed to it.
A fast blinking logo power button means
there is an over or under voltage situation
and the unit has shut off. This occurs at 130
(260) volts on the high side and 100 (200)
volts on the low side. The Power Center
should automatically turn back on when the
voltage on the line has returned to normal.
If it does not, simply press the logo power
button to reactivate the Power Center.
If the logo light fl ashes slowly, it means the
Power Center
won’t turn on
Check the logo
Use the correct
voltage
Fast blinking vs.
slow blinking
If the power light
blinks