202-045-0200 page 1 august 2017 pac45 pilot guide 9800 martel road lenoir city, tn 37772 www.Ps-engineering.Com pac45 system flying never sounded so good!® pilot’s guide and operation manual for dual control head systems 202-045-0200 faa-tso c139a august 2017 ps engineering, inc. 2017 © copyright no...
Page 2 202-045-0200 august 2017 pac45 pilot guide this pilot guide provides detailed operating instructions for the ps engineer- ing pac45, audio selector panel/intercom systems. Please read it carefully before using the equipment so that you can take full advantage of its capabil- ities. Note: beca...
202-045-0200 page 3 august 2017 pac45 pilot guide ctl45p operating controls power and fail safe unit power is controlled by the transmitter (xmt) selector knob. In the "emg" or off (fully clockwise) position, the pilot headset is connected directly to com 1 as well as alerts and unswitched input #1....
Page 4 202-045-0200 august 2017 pac45 pilot guide you will always hear the audio from the selected transceiver, even if the selected comm audio is turned all the way down on the audio controller because it cannot turn the selected receive audio all the way off. The volume of the received source is a...
202-045-0200 page 5 august 2017 pac45 pilot guide hrtf button for > 1 second on the pilot’s panel until the hrtf button and all com nomenclature start blinking green. Rotate the desired com receive volume knob so the pointer indicates the approximate location of the desired location. A voice announc...
Page 6 202-045-0200 august 2017 pac45 pilot guide note it is also a good idea to keep the microphone out of a direct wind path. Moving your head through a vent air stream may cause the intellivox® to open momentarily. This is normal. The intellivox® is designed to work with normal aircraft cabin noi...
202-045-0200 page 7 august 2017 pac45 pilot guide note: mono headsets that short the tip and ring (i.E. Older models) will introduce some audio distortion when used. Modern, stereo headsets are recommended in all positions. Intercom modes the “ics” pushbutton switch on the panel provides the selecti...
Page 8 202-045-0200 august 2017 pac45 pilot guide fault access code is not required. Once the pac45 has been “paired” with your bluetooth device, the tel distribution will act as described below. Pairing bluetooth® devices the pac45 can be paired with up to eight individual devices, but will only co...
202-045-0200 page 9 august 2017 pac45 pilot guide bluetooth reset if the bluetooth stops connecting to a device, or operates incorrectly first try turning bluetooth off, and back on from your device. If also me be necessary to reset the bluetooth module, clearing out the connected devices. Press hrt...
Page 10 202-045-0200 august 2017 pac45 pilot guide 7. When finished with alert #2, press the “ack” 8. Now com3 blinks, to indicate the recording of alert #3. 9. Speak message. 10. When finished with alert #3, press the “ack” 11. A chime indicates that recording is now finished. Note: if ack is not p...
202-045-0200 page 11 august 2017 pac45 pilot guide subject index page audio alerts storing alert audio 9 audio location (hrtf) 4 bluetooth® connection bluetooth reset bluetooth® telephone mode pairing and unpairing bluetooth devices pairing separate music and telephone devices 7 com audio selector 3...
Page 12 202-045-0200 august 2017 pac45 pilot guide ps engineering, inc. 2017 © copyright notice copyrighted information in this manual is subject to change without notice. Ps engineering reserves the right to improve or change the products or contents of this manual, without notification of any pers...
