Owner’s manual model cbr iii model cbr iii ss prizelawn ® cbr ll l commercial broadcast spreader.
Assembly 1. Remove the spreader and components from carton and place hopper up-side down on a padded surface as shown. Insert ends of leg into handle brace as shown and align holes. Attach brace and leg to frame using (4) 1/4-20 x 2” hex bolts, lockwashers, and nuts. 3. Turn spreader upright on whee...
4. Slide handle lever between handle brackets as shown and secure with (1) 1/4 dia. Clevis pin and 3/32” dia. Cotter pin. Make sure lever pivots freely. Install handle grips onto upper handle. 5. Install control tube to handle lever with (1) 1/4 dia. Clevis pin and a 3/32” dia. Cotter pin. Slip oppo...
1. Check the product package for the rate setting, and recommended swath width. Loosen rate control knob and slide rate plate to the proper setting. The pattern is controlled by loosening the two knobs on the discharge chute and moving the chute closer or farther away from the impeller (setting a, b...
A simple visual pattern test can be made by operating the spreader over a non- turf area and evaluating the pattern. A more accurate method is to place a row of common, disposable, aluminum cake pans approximately 1 foot on centers. Set the rate plate at a middle setting and make 3 or 4 passes in th...
Fertilizer particle size bag rate pounds of fertilizer used per 1,000 sq. Ft. Of coverage approx. Setting spread width (in feet) large, heavy particles 5 10 15 m o q 8 8 8 medium- mixed particles 5 10 15 l n o 8 8 8 small particles (nitrogen) 1 2 3 g j l 8 8 8 mixed size particles -some fines 5 10 1...
Fertilizer particle size bag rate pounds of fertilizer used per 1,000 sq. Ft. Of coverage approx. Setting spread width (in feet) large, heavy particles 5 10 15 g h j 8 8 8 medium- mixed particles 5 10 15 f g h 8 8 8 small particles (nitrogen) 1 2 3 d e f 8 8 8 mixed size particles -some fines 5 10 1...
1. Never store unused material in spreader. Return unused product to its original container. 2. Wash spreader thoroughly after each use and dry completely in sun or heated area. 3. Grease axle bearings in frame. Oil the impeller shaft bearing in hopper, pivot points on the shut- off plate and the sp...
No. Description cbr iii cbr iii ss no. Description cbr iii cbr iii ss 1 hopper assembly 14610-2 14610-2 17 impeller shaft bearing* 14312-1 14312-1 1a hopper* 14604 14604 18 drive wheel 15032 15032 2 discharge chute* 14623 14623 19 leg 15007-1 15189 3 discharge chute knob (2)* 14001 14001 20 impeller...
