PSB Synchrony Series Owner's Manual - Adjusting Rubber Levelers

Adjusting Rubber Levelers 

and Spikes 

(Tower Speakers)

Attach the supplied spikes or rubber 

levelers to the bottom of the speaker  

as shown in the diagram at right. On 

carpets, position the speakers and 

adjust spikes to the desired height 

(higher for thicker carpet) and hand 

tighten the locknuts against the bottom 

of the cabinet.  

Adjusting Rubber Foot

(For Center Channel Models)

The Synchrony One C and Two C 

center channel speakers come supplied 

with a multi-position foot that allows 

them to be placed at a variety of 

angles.

Notice that the foot has a long edge and a 

short edge. Either surface may be 

attached to the system depending on the 

angle of tilt required.   An adhesive strip is 

provided to permanently attach the foot to 

the cabinet.  

When placed below your viewing screen 

you can tilt the system upwards by placing 

the foot under the front edge of the 

system.  To aim the system straight 

outward, place the foot under the rear 

edge with the longer side in contact with 

the system.  It will be raised by the shorter 

dimension.  If the system is well above 

your viewing screen and a downward tilt is 

required, then attach the shorter 

dimension to the back of the cabinet.  This 

will give the maximum rise for the greatest 

downward tilt.

Apply the provided felt discs to the corners 

of the opposite edge (front or back) to 

prevent marring your system or equipment 

cabinet.

6

Owner

’s

 Manual