Enjoy your qca jewel +3 series spa ml 700 panel owner’s manual this owner’s manual is for you! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for ...
Table of contents cleaning the filter cartridge..........................................11 draining the water .........................................................10 filter maintenance ..........................................................11 hydro-, turbo-, air-max(tm) ........................
3 ul instructions the instructions you are about to read are required to be published in your manual by the underwriters laboratories. These instructions are very important for your safety and qca would like to encourage you to read and apply all instructions. Thank you! Important safety instruction...
Warning - the use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia in hot tubs and spas. S p a l o c a t i o n the selection of a site for the installation of your spa is a very important decision and should be undertaken keeping several factors in mind. 1. Always...
Jewel +3 series spas initial start-up when your spa is first powered up, it will automatically heat and maintain 100 °f until you change the set temperature. In the event of a power failure or during a manual shutdown, the spa will revert to the last set temperature, mode, and filter cycle before th...
Standby mode pressing “warm” or “cool” then “jets 2” will turn off all spa functions temporarily. This is helpful when changing a filter. Press any button to exit standby mode. Jets 1 press the “jets 1” button once to turn pump 1 on, again to switch to high-speed. Pressing for a third time turns pum...
7 locking the temperature press “temp” jets 1” then the “warm” with in 3 seconds. When locked the pl indicator light will light. All buttons are frozen except the “temp” button. To unlock panel, press “temp” “jets 1” then “cool.” temperature display inversion press the “warm” or “cool” button, follo...
Takes 4 min spa and maintain the water temperature in the standard mode. --f ° or --c°temperature unknown. After the pump has been running for 2 minutes, the temperature will be displayed. ---- temperature not current in economy or sleep mode. In economy or sleep mode, the pump may be off for hours ...
Jewel series jets directional hurricane jet-the graphite gray jet is operated by rotating the jet face counter-clockwise to full on position or clockwise for 95% shut-off. Massage jet-the graphite gray jet is operated by rotating the jet face counter-clockwise to full on position or clockwise for 95...
Spavac™ kit – optional your qca spavac™ can be used with garden hose pressure or provided vacuum hose. Your qca majestic spa is equipped with a wall skimmer. For use with garden hose, the spavac™ is equipped with a fine mesh screen bag which can be easily cleaned after use. For use with the vacuum h...
Note: not maintaining your water can result in damage of your spa jets, filter, etc. This damage, due to incorrect water maintenance, is not covered under warranty. Filter maintenance as with any water filtering system, the filter cartridges may become clogged with particles or with calcification th...
Low-speed pump is automatically activated. This is a normal spa function; no corrective action is necessary. Freeze protection is enabled regardless of the spa's status. Winterizing in very cold weather you may not want to venture outside to use your spa. In this case, you may move it to a heated ar...
To receive your free gift to help maintain your spa and to validate your spa warranty, return the prepaid registration card below within the next thirty days. To immediately register your new spa; you may log onto our web site at qcaspas.Com. 13.
