Enjoy your qca spa vs300 pak (vl260 topside) owner’s manual this owner’s manual is for you! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for ref...
Table of contents cleaning the filter cartridge ...........................................................................8 diagnostic messages ........................................................................................6 draining the water .................................................
Ul instructions the instructions that you are about to read, are required by underwriters laboratories to be published in your manual. These instructions are very important for your safety and qca would like to encourage you to read and apply all instructions. Thank you. Important safety instruction...
Spa location the selection of a site for the installation of your spa is a very important decision and should be undertaken keeping several factors in mind. 1. Always check your local codes before installing your spa. A clear understanding of buildings, fences, gates, electrical and plumbing guideli...
Your • qca • spa • equipment vl260 series control initial start up when your spa is first actuated, it will go into priming mode, indicated by “pr.” the priming mode will last for less than 5 minutes (press "temp" to skip priming mode) and then the spa will begin to heat the spa and maintain the wat...
Diagnostic messages message meaning action required no message on display. Power has been cut off to the spa. The control panel will be disabled until power returns. Spa settings will be preserved until next power up. -- temperature unknown. After the pump has been running for 2 minutes, the tempera...
7 qca spa light all equipment modules have a receptacle, located on the equipment module. This receptacle is provided for the connection of the spa light. Your qca spa has a standard 12v light. The spa light may be turned on or off by pressing the light button, located on the spa side control. The l...
Water care daily checklist 1. Test for proper bromine or chlorine level. Proper bromine level should be maintained at 2.0 - 4.0 ppm. 2. Test ph levels and adjust if needed. If you are having difficulty keeping ph properly balanced, it may be an indication that total alkalinity needs adjusting. Have ...
9 3. Upon your return, check the level of sanitation of your spa water. If the chlorine test reads "o" and you have been gone an extended period of time, superchlorinate the spa water to ensure all organisms and algae are oxidized. The spa water will be safe for you to use once the free chlorine res...
Warranty registration this warranty applies to spas manufactured by qca spas and sold to an original consumer purchaser at retail ("purchaser") after january 1, 2008. To validate this warranty, the purchaser must complete the enclosed warranty registration card and mail it to qca spas within 30 days...
