QED ROOMLINK RL-SP3 Installation

ROOMLINK is designed to offer the benefits of controlling your remote control video or hi-fi system

from any room you choose.

ROOMLINK is derived from the more sophisticated award winning SYSTEMLINE multi-room system,

and  as  such  benefits  from  the  considerable  design  expertise  gained  with  that  project.

ROOMLINK works by allowing the original hi-fi system (or video) remote control handset to be used

from any room you choose, the infra-red codes being received by a wall mounted sensor placed in the

extension room. The sensor then relays the codes back to the equipment in the main room. In addition

to the sensor, a speaker on/off switch or Speaker Volume Control is normally fitted in the extension

room,  as  this  allows  local  control  over  sound  selection.  (see  section  3  for  examples).

NOTE:   "Please  note  that  a  small  number  of  IR  codes  will  not  pass  through  Roomlink  successfully.

Please  ensure  complete  operation  before  running  wires  and  installing  back  boxes  etc."

ROOMLINK is not suitable for use with most B&O and some satellite and cable equipment, as their infra-

red carrier system operates at a non-standard frequency.

1) ONE x ROOMLINK DRIVER

2) TWO x FLOOD EMITTERS (SL-FE)

3) ONE x PLUG TOP POWER SUPPLY (UK ONLY)

STARTER PACK 3 CONTENTS

ROOMLINK is available as a starter pack which incorporates the following:

4) ONE x ROOMLINK SENSOR (including plug-in connector)

5) TWO x WINDOW EMITTER PACKS (SL-DE)

ROOMLINK RL-SP3 STARTER PACK

Installation Document