1. DL manuals
  2. QEP
  3. Saw
  4. 60024
  5. Owner's Manual

QEP 60024 Owner's Manual

Manual is about: 24" PROFESSIONAL TILE SAW

Summary of 60024

  • Page 1

    ?aviso! Lea y siga todas las instrucciones de funcionamiento y seguridad antes de usar esta sierra. Stk# 60024 owner’s manual manuel d’utilisation manual de operaciÓn 24" professional tile saw scie Á carreaux professionnelle de 61cm sierra de losetas profesional de 61cm caution! Read and follow all ...

  • Page 2: 24" Professional Tile Saw

    - 2 - table des matiÈres instructions de sécurité pour les scies à carreaux......................12 exigences Électriques ..................13 avertissement ..............................14 fonctions de pointe ....................14 spécifications – Électrique et moteur ................................

  • Page 3

    - 3 - safety instructions for tile saw read this owner’s manual completely and make sure you understand all of it’s safety guidelines. 1. Keep guards in place and in working order. 2. Remove adjusting keys and wrenches. Before turning on the tile saw, make sure the keys and adjusting wrenches have b...

  • Page 4

    - 4 - 29. Positioning of tile saw (see illustration 1) a. To avoid the possibility of the appliance plug or receptacle getting wet position the tile saw to one side of a wall-mounted receptacle to prevent water from dripping onto the receptacle or plug. The user should arrange a “drip loop” in the c...

  • Page 6

    - 6 - blade & blade guard installation 1. The blade guard (2) must be installed before the diamond cutting blade (3) can be attached. (see diagram) 2. Use the blade guard adjustment knob (1) to fasten the blade guard firmly against the motor assembly. 3. Carefully raise the cutting head to its highe...

  • Page 7

    - 7 - water pump installation 1. Remove the water pump from its box and ensure that it is not cracked or damaged in any way (see diagram) 2. Attach the end of the plastic tubing, hanging down from the blade guard, to the water pump nipple. 3. Place the water pump in the rear of the water tray on its...

  • Page 8

    - 8 - cutting depth 1. The recommended cutting depth for all materials is 1 ⁄ 4 " below the top surface of the cutting table. (see diagram) 2. To adjust cutting depth, loosen the large motor mounting plate adjustment knob, and move up or down. Belt replacement caution: always turn off saw and unplug...

  • Page 9

    - 9 - saw operation 1. Make sure you have read this manual completely before operating your saw. 2. Make sure that there is sufficient water in the water pan to cover the inlet on the water pump, and that water is being supplied to the saw blade before attempting to cut any material. 3. Make sure yo...

  • Page 10

    - 10 - description no. Folding saw stand w/wheels 60024-01 wheel / brake assembly (w/4 bolts, washers, nuts) 60024-03 stand knobs (2) 60024-04 frame assembly 60024-05 roller guide bar (w/2 bolts, washers, nuts) 60024-06 water tray assembly 60024-07 drain plug 60024-08 angle bar on water tray (w/2 bo...

  • Page 11

    - 11 - exploded parts table extension front easily slips onto the leading edge of the cutting table for maximum support when cutting larger tile. Miter block table extension side easily slips onto the leading edge of the cutting table for maximum support when cutting larger tile. 60024 manual-tri.Qx...