Master cut portable tile saw instruction manual model no.60707 carefully read the instruction manual before you use this machine, and save this instruction manual for future reference. - 1 -.
Page 1 2 3 4 5 6 7 8 9 10 warning symbols general safety instructions for power tools special safety instructions for tile cutter technical specifications technical specifications electrical safety unpacking loose parts list features assembly and operation assembly of the tile cutter fitting the til...
Warning symbols warning! There are six warning symbols on the warning label which is affixed to the tile cutter. The purpose of warning symbols is to attract your attention to possible hazardous conditions. The progression of warning symbols is described below. Remember that safety messages by thems...
- 4 - general safety instructions for power tools important! When using electrical tools, the following safety instructions should be observed to prevent the risk of electric shock, personal injury and fire. Read and observe these instructions carefully before using the tile saw. 1. Keep work area c...
Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before switching it on. 17. Avoid unintentional starting do not carry plugged-in tools with finger on switch. Be sure that the tool is switched off before plugging in. 18. Outdoor use extension cords when to...
Wear, or looseness. Replace any damaged or worn parts. Always disconnect from power before changing or adjusting the blade. 9. Blade direction check that the directional arrow on the saw blade and the motor shaft are rotating in the same direction. 10. Blade arbor ensure the blade arbor hole size ma...
Supply (±10% ac 230v), the rotational speed of the spindle will never exceed the rated no-load speed. Grounding in the event of an electrical short circuit, grounding reduces the risk of electric shock by providing a path of least resistance to disperse electric current. This machine is equipped wit...
Blade guard parallel guide 180mm continuous rim diamond blade miter gauge features before attempting to use, familiarize yourself with all the operating features and safety requirements of your tile cutter. Figure 1. Front view of tile cutter blade blade guard miter gauge parallel guide table water ...
Blade this machine comes with a standard Φ 180mm blade w/bore 22.2mm diamond blade. Warning! Only use the continuous rim diamond blade. Blade guard protects the operator from coming in contact with the blade. Miter gauge diagonal cuts can be made on rectangular tiles using the supplied miter gauge. ...
Assembly and operation assembly of the tile cutter on the workbench figure 2 shows the dimensions of mounting holes which have been pre-drilled on the machine frame. 1. Drill three holes in the workbench as the same dimensions as fig. 2. 2. Fasten the machine with bolt onto the workbench. Warning! O...
Figure 4: diagonal cutting with the miter gauge. Bevel cutting the work table can be tilted up to 45 0 to accommodate bevel cutting. Loosen the knob on the front of the tile cutter as shown in figure 5. Use the scale on the front of the tile cutter to set the desired table tilt angle. Retighten the ...
Exploded view - 12 -.
Parts list part no. Description q’ty part no. Description q’ty 1 nut (m5) 1 26-5 fixing plate 1 2 blade guard 1 26-6 capacitor 1 3 plastic pad 4 26-7 rubber tube 1 4 nut 1 26-8 vde cable & plug 1 5 riving knife 1 27 washer 2 6 bolt 1 28 screw 2 7 washer 2 29 knob 2 8 screw 2 30 nut 2 9 pin 1 31 nut ...
- 14 - 26-3 switch 1 26-4 terminal block 1.
