QFX CR-91NOA Operating Instructions Manual - My Favorite Stations
improve the reception.
AM: Rotate the unit horizontally for optimum
reception. A ferrite bar antenna is built into the
unit.
Do not operate the unit over a steel desk or metal
surface, as this may lead to interference of
reception.
---------------------------------
My favorite stations
In FM/AM mode, you could manually store a
particular frequency as your favorite station.
1
Tune to desired station, press SET over
one second till the display is flashing P-X.
2
Press UP/DOWN (TUNING buttons) to
choose the desired memory (01-30). Press
SET to complete the storing action.
• When P-X is flashing, If you do not press SET,
the flashing will stop after four seconds and the
storing action will be canceled.
To switch to your preset favorite stations,
simply press P+, or press P+ and then press
UP/DOWN.
---------------------------------
Auto-scan all stations
In FM/AM mode, the unit could auto-scan
and store up to 30 stations.
1
Tune on the radio, press BAND to switch
to FM or AM, press SET over 5 seconds
until the unit start scanning the frequency.
2
You could stop the auto-scan process by
pressing any button.
• The auto-scan will store station from the 1
st
memory and so on. Previously stored memory will
be erased.
---------------------------------
Setting the Alarm
To set the alarm, the unit should be at
standby mode first.
1
Press AL (AL1/AL2), the display will flash
the alarm type (Buzzer / Radio) and then the
alarm time.
2
To set the alarm type, simply press AL
again when the word “BuZ” or “RAd” is
flashing. It cycles between buzzer, radio and
off.
• The AL1 and/or the AL2 indicators will light up if
the alarm is turned on.
3
To set the alarm time, press HOUR /
MINUTE when the alarm time is flashing.
Press SET to finish, or wait 4 seconds.
• The alarm will come on at the preset time and
automatically turn itself off after 60 minutes.
• The Radio-alarm will turn on the unit to the last