Qi Harmony User Manual - page 4
7
6
Qì Harmony / User Manual
Qì Harmony / User Manual
Installing the support bases
1.
Open the box, take out the unit and remove the protections. Make
sure that the unit is in perfect condition.
2.
Turn the heater over leaving the base face up.
3.
Fix the supports to the base with the corresponding fixation screws.
Once you have done this, stand the heater up on its base and ensure
that the support has been correctly installed.
Precautions before using
1.
Always place the unit in a stable position, and then insert the plug
securely into the electrical outlet.
2.
Please do not connect the plug into the electrical outlet until you
have installed the support base and ensured it is properly installed.
3.
Please always maintain the humidifier water compartment with the
minimum amount of water required.
Instructions for use of the foldout hanger
1.
Please fold out the clothes hanger before turning the heater on, if
you are going to use it to dry clothes.
2.
If you have not folded out the clothes hanger before turning the
heater on, please do not take them from the middle as you could
burn yourself.
3.
Please do not hang heavy objects from the clothes hanger as you
may damage them or deform them.
4.
Please make sure that the clothes are not dripping wet before hanging
them on the clothes hangers.
5.
Please do not hang big objects (carpets, rugs, quilts, etc.) on the
clothes hangers as this will damage them and could cause accidents
if the heater falls over.
Attention: Because this heater has roll-over protection it will only operate
if it is standing on flat and levelled floors. The heater also has a thermal
protection system that will be activated in case of overheating, turning the
heater off. The heater can only be turned back on again once it has cooled.