QLOCKTWO LARGE Instructions For Use Manual - page 7
13
12
Turning “IT IS” on/off
The introductory words “IT IS” can be turned on and off. To do so, press the ( 60 ) button for approx.
3 seconds. The words always appear when the mode is activated. In “purist mode” (factory setting)
“IT IS” only appears every full and half hour.
Infrared remote control
All functions mentioned can also be controlled via the supplied infrared remote control. Simply point the
remote upwards towards the bottom of the QLOCKTWO LARGE. The infrared receiver is positioned at the
back of the QLOCKTWO LARGE.
Seconds mode
To select the seconds mode press the ( ) button for longer than 3 seconds. The seconds will
appear as large numbers in the matrix. By pressing any button QLOCKTWO LARGE resumes
standard operation.
Setting the level of brightness
The LEDs’ brightness automatically adjusts to the surrounding light. You can also manually
set the level of brightness. By repeatedly pressing the ( ) button you can change the level of
brightness according to the following pattern:
Maximum brightness
Normal brightness
Medium brightness
Low brightness
Automatic mode (the dots in the corners briefly light up)