QMS Magicolor 2 CX Supplementary Manual - page 6

Conversion 

Procedure

QMS magicolor DeskLaser to CX Conversion

4

Verifying the Conversion

To verify the conversion, turn on the printer. A start-up page, 

identifying the printer as a QMS 

magicolor 2, automatically prints. 

This indicates that the printer has successfully been converted from a 

QMS 

magicolor 2 DeskLaser to a QMS magicolor 2 CX Print System.

Applying the Identification Labels

Use the following illustrations to install the new dataplate and product 

ID logo on the printer.

Product ID Logo

8

Align the 

magicolor 2 CX controller 

board on the plastic guides, and then 

slide it into the printer. 

Make sure it’s properly seated in its con-

nectors, but do not force it.

9

Tighten the two mounting screws.

10 Reconnect the interface cables and 

power cord, and then turn on the printer.

QMS magicolor 2 

Product ID Logo

P/N 1241121-002

(Apply over the existing 

product ID logo.)