1. DL manuals
  2. QNAP
  3. Enclosure
  4. REXP-1000 Pro
  5. Hardware User Manual

QNAP REXP-1000 Pro Hardware User Manual

Manual is about: RAID Expansion Enclosure

Summary of REXP-1000 Pro

  • Page 1

    Qnap raid expansion enclosure hardware user manual © 2014. Qnap systems, inc. All rights reserved. Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480, г.Москва, ул.Туристская, д.33/1; site: https://andpro.Ru тел: +7 (495) 545-4870 email: info@andpro.Ru...

  • Page 2

    2 thank you for choosing qnap products! This user manual provides descriptions of the hardware of the qnap raid expansion enclosure and relevant guidelines of certain functions. Please read this manual carefully and strictly adhere to its instructions. This user manual is applicable to the following...

  • Page 3

    3 disclaimer in no event shall the liability of qnap systems, inc. (qnap) exceed the price paid for the product from direct, indirect, special, incidental, or consequential software, or its documentation. Qnap makes no warranty or representation, expressed, implied, or statutory, with respect to its...

  • Page 4

    4 regulatory notice fcc statement this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment g...

  • Page 5

    5 symbols in this document warning this icon indicates the instructions must be strictly followed. Failure to do so could result in injury to human body or death. Caution this icon indicates the action may lead to disk clearance or loss or failure to follow the instructions could result in data dama...

  • Page 6

    6 contents contents .......................................................................................................................................................... 6 safety warnings ..............................................................................................................

  • Page 7

    7 safety warnings 1. The raid expansion enclosure can operate normally in the temperature of 0ºc–40ºc and relative humidity of 5%–95%. Please make sure the environment is well-ventilated. 2. The power cord and devices connected to the raid expansion enclosure must provide correct supply voltage (100...

  • Page 8

    8 warning: danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions. Do not touch the fan inside the raid expansion enclosure to avoid serious injuries...

  • Page 9

    9 before you start 1. The raid expansion enclosures can only be used with the qnap turbo nas. 2. Install the hard drives in sequential order following the tray number. 3. The raid expansion enclosures are applicable to the ts-x79 and ts-ecx80 turbo nas series. 4. Always turn on the raid expansion en...

  • Page 10

    10 storage expansion card (optional purchase) 1 1.2. Rexp-1000 pro the product package contains the following items. Item picture quantity rexp-1000 pro 1 power cord 1 screw pack 1 quick installation guide 1 0.5m mini sas cable 1 hardware installation cd 1 storage expansion card (optional purchase) ...

  • Page 11

    11 2. Hardware specification the physical specifications, operating environment, and power requirements of the raid expansion enclosure are listed below. 2.1. Rexp-1200u-rp and rexp-1600u-rp rexp-1200u-rp rexp-1600u-rp host interface two sas 4x wide port (in port, out port) hard drive 12 x 3.5-inch ...

  • Page 12

    12 power supply input: 100-240v ac, 50-60hz; output: 600w com port reserved for system maintenance fan 3 x 6 cm smart cooling fan management (via nas) 1. Supports disk s.M.A.R.T. Information 2. Raid expansion enclosure identifier 3. Locate raid expansion enclosures 4. Locate hard disks on raid expan...

  • Page 13

    13 2.2. Rexp-1000pro model rexp-1000 pro host interface two sas 4x wide port (in port, out port) hard drive 10 x 3.5-inch sas/sata 6gb/s, sas/sata 3gb/s hard drive 2.5-inch sas/sata, ssd hard drive note: the standard system is shipped without hard drives. For the hard drive compatibility list, pleas...

  • Page 14

    14 6. In-band sas firmware update Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480, г.Москва, ул.Туристская, д.33/1; site: https://andpro.Ru тел: +7 (495) 545-4870 email: info@andpro.Ru При обращении используйте промокод and-pdf и получите скидку..

  • Page 15

    15 3. Raid expansion enclosure hardware illustration caution: modifying the hardware, software, or firmware of qnap products will void the warranty. Qnap is not responsible for any form of damage or loss of data caused by users modifying qnap products. Users should bear their own risks of all sorts ...

  • Page 16

    16 4 release button 5 hard drive tray caution: always turn on the raid expansion enclosure before turning on the attached nas. Always shut down the nas before turning off the raid expansion enclosure. Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480,...

  • Page 17

    17 led color state description system status green green the system is ready flash green the system is starting up off the system is off system fault amber amber system fault detected (overheat, fan error, power supply unit fails or is plugged out, etc.) off no fault has occurred system over heat am...

  • Page 18

    18 3.2. Rear view rexp-1200u-rp rexp-1600u-rp 1 com port (reserved) 2 in port 3 in/out port status led 4 out port 5 power switch 6 enclosure id 7 power connection Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480, г.Москва, ул.Туристская, д.33/1; site...

  • Page 19

    19 led color state description link status green green port linked flash green data is being transmitted off no link activity link fault amber amber port linked but without all four lanes flash amber sas cabling error off no fault has occurred table 2: raid expansion enclosure in/out port status led...

  • Page 20

    20 system status green green the system is ready flash green the system is starting up off the system is off amber amber system fault detected (overheat, fan error, power supply unit fails or is plugged out, etc.) off no fault has occurred system over heat amber amber the system overheat off no faul...

  • Page 21

    21 3.4. Rexp-1000 pro rear view 1 power connection 2 power switch 3 k-lock 4 in port 5 out port 6 com port (reserved) 7 system cooling fan Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480, г.Москва, ул.Туристская, д.33/1; site: https://andpro.Ru тел:...

  • Page 22

    22 4. Cable the system 4.1. Cabling instructions an example of connecting a qnap nas to four rexp-1200u-rp enclosures is shown below. 1 connect the qnap nas to the rexp-1200u-rp: if two (or above) rexp-1200u-rp enclosures are configured, connect the two storage expansion ports on the nas to two rexp...

  • Page 23

    23 an example of connecting a qnap nas to four rexp-1000 pro enclosures is shown below. 1 connect the qnap nas to the rexp-1000 pro: if two (or above) rexp-1000 pro enclosures are configured, connect the two storage expansion ports on the nas to two rexp-1000 pro enclosures for maximized performance...

  • Page 24

    24 4.2. Mini sas cable removal follow the steps below to remove the mini sas cable. 1. Pull up the restraining clip latch of the mini sas cable. 2. Remove the mini sas cable from its restraining clip. Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480,...

  • Page 25

    25 5. Remove an air duct (applied to rexp-1600u-rp) unlatch the air duct with your thumb and index finger. Pull the air duct upward to disengage it from the raid expansion enclosure. Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480, г.Москва, ул.Тури...

  • Page 26

    26 6. Install/remove a fan module 6.1. Install a fan module (applied to rexp-1600u-rp and rexp-1200u-rp) insert a fan module into the fan slot until the fan module is fully seated. Warning: to avoid system overheating, replace the fan module within 3 minutes. Do not attempt to operate the system wit...

  • Page 27

    27 7. Install power supply unit (applied to rexp-1600u-rp an d rexp-1200u-rp) warning: the raid expansion enclosure supports replacing a redundant power supply unit without turning off the enclosure when the redundant power supply mode is enabled. However, users are strongly recommended to turn off ...

  • Page 28

    28 3. Unplug the failed power supply. 4. Plug in a new power supply. 5. Turn on the raid expansion enclosure. Проконсультироваться и купить данное оборудование вы можете в компании «АНД-Системс» адрес: 125480, г.Москва, ул.Туристская, д.33/1; site: https://andpro.Ru тел: +7 (495) 545-4870 email: inf...

  • Page 29

    29 technical support qnap provides dedicated online support and customer service via instant messenger. Online support: http://www.Qnap.Com msn: q.Support@hotmail.Com skype: qnapskype forum: http://forum.Qnap.Com technical support in the u.S. And canada: email: q_supportus@qnap.Com tel: 909-595-2819...