QSC KLA AF12 Quick Start Manual - page 3
4
Attaching to a KLA12 Loudspeaker
AARNRNG!:
A KLA Array consists of one of the following array configuration options. The maximum number of KLA12
Loudspeakers in any array, with or without KLA181 Loudspeakers, is five.
1. Refer to
— Figure 4
. Make sure that the levers labeled "B" are up, and slides
(1)
are down on both sides of the loudspeaker.
2. Refer to
— Figure 5
. Place the assembled KLA AF12 Array Frame, on top a KLA12. Nest the four feet
(1)
on the array frame into the feet receptacles
(2)
on the loudspeaker. Make sure that the surfaces are aligned and parallel.
3. On the bottom loudspeaker, push button "A". Slide
(1)
automatically moves to
Up Position
.
4. Rotate Lever "B" down to the
Locked Position
.
AARNRNG!:
Make sure the loudspeakers are properly aligned, and that the Lever locks are in the down, locked position. Lift
array a small amount to confirm assembly.
— Figure 4 —
1
— Figure 5 —
1
2
— Figure 6 —
ROTATE DOWN
PUSH
1
B
SLIDES UP