QSC KLA AF12 User Manual - page 13
13
Attaching a KLA181 to a KLA AF12 Array Frame
Refer to
Figure 18
NOTE:
The KLA AF12 Array Frame must be oriented with the
KLA181 feet pointing down as shown in
Figure 18
. For more detail,
refer to
Figure 3 on page 8.
1. Place the KLA181 on the floor, or other suitable surface, and make sure the
hooks are retracted. If not, insert the supplied 6 mm hex key into the hex socket
(Figure 17, 4 on page 12)
and rotate the key fully to the
Unlocked Position
as noted next to the hex socket on the loudspeaker.
2. Place the KLA AF12 Array Frame on top of the KLA181. The Array Frame feet
(2)
align, and nest into, the spaces
(1)
in front of and behind the attaching hook
in the KLA181 rigging plates. When properly nested, you should not be able to
move or slide the top unit without lifting it.
NOTE:
The KLA AF12 is reversible front to back, you can mount it
on the loudspeaker with the Extension Bar pointing either direction.
Point the Extension Bar pointing towards the front of the array for maximum upward tilt, towards the rear of the array for maximum
downward tilt.
Refer to
Figure 19
3. Insert the 6 mm hex key (supplied) into the hex socket
(1)
in the KLA181.
4. Turn the key fully to the
Locked Position
as noted next to the hex socket on the
loudspeaker. Refer to
Figure 17 on page 12
for details
a. In the
Retracted Position
, you cannot see the hook in the view hole
(2)
.
b. When the hook reaches the
Up Position
, the hook almost completely fills the
view hole
(2)
in the KLA AF12 Array Frame.
c. In the final,
Locked Position
, you can see a small portion of the hook in the
bottom of the view hole.
5. Repeat for the other side of the loudspeaker. At this point, the loudspeaker and array frame are securely attached and are ready for suspension.
Separating a KLA181 from a KLA181 or KLA AF12
Refer to
Figure 20
1. Place the two assembled KLA181 loudspeakers (or loudspeaker and array frame) on the floor or
other suitable surface. If the two loudspeakers are suspended, lower them until the weight of both
loudspeakers is completely supported by the floor or suitable surface.
2. Insert the 6 mm hex key into the hex socket
(1)
on the side of the lower KLA181.
3. Turn the hex key fully to the
Unlocked Position
as noted next to the hex socket on the
loudspeaker. If the weight of the loudspeaker(s) is not completely supported from the bottom,
you will not be able to turn the hex key fully to the
Unlocked Position
, or separate the units.
4. Repeat on the other side of the loudspeaker.
5. You can now separate the units.
— Figure 21 —
1
2
— Figure 22 —
KLA-AF12
KLA181
2
1
— Figure 23 —
1