QSC KLA series Quick Start Manual - Rigging A Kla12 to A Kla181
3
TD-000335-00-C
Rigging a KLA12 to a KLA181
The KLA12 cannot be rigged to the top of a KLA181.
There are various ways to facilitate rigging a KLA12 to a KLA181, and they vary depending on the specifi c circumstances. Be sure to use proper rigging
techniques, and/or employ a professional engineer. Following is one example.
Suspend the KLA181 as described in
"Other KLA181 Deployment" on page 4
, then carefully rig a KLA12
to the bottom of the KLA181 using the KLA12 rigging system. Continue rigging the remaining KLA12s to
the array.
1. Make sure that levers
(1)
and slides
(2)
(on both sides of the KLA12 loudspeaker), are in the positions
shown in
Figure 5 "Retracted Position"
.
Refer to
Figure 4
.
2. Place the top of the KLA12 up to the bottom of the KLA181 such that the front feet on the KLA181 nest into
the feet receptacles on the top of the KLA12.
IMPORTANT:
The front and sides of the KLA12 should be aligned fl ush with the
front and sides of the KLA181. When the front feet of the KLA181 are properly
nested into the feet receptacles of the KLA12, there will be no gap between the
two boxes.
Refer to
Figure 5
3. On the KLA12 loudspeaker with the hook
(2)
in the Retracted Position, push button "A" to release slide
(1)
. Slide
(1)
automatically moves
upward, and the hook
(2)
automatically rotates to the Up Position. In the Up Position, the hook fi lls the view hole
(3)
in the KLA181.
4. On the KLA12 loudspeaker, pull lever "B" downward to lock the hook
(2)
in the Locked Position and secure the loudspeakers. When the hook
(2)
is properly latched, you can only see a portion of the hook
(2)
through the view hole
(3)
.
WARNING!:
Make sure that the lever "B" locks in the downward, Locked Position indicating that the hook itself is locked. If the
locking mechanism is not properly latched, the loudspeakers could separate and cause physical damage to the loudspeakers,
and/or personal injury.
5. Repeat the procedure for the other side of the loudspeakers, and for all KLA12 loudspeakers in the array. The loudspeakers are ready to suspend.
— Figure 4 —
— Figure 5 —
2
1
A
B
3
2
1
B
3
B
2
3