1. DL manuals
  2. QSC
  3. Pager
  4. Q-SYS PS-1600
  5. User Manual

QSC Q-SYS PS-1600 User Manual

Manual is about: Networked Page Station

Summary of Q-SYS PS-1600

  • Page 1

    Networked page station user manual ps‑1600(h/g) – sixteen-button page station ps‑1650(h/g) – sixteen command-button page station ps‑800(h/g) – eight command-button page station ps‑400(h/g) – four command-button page station page stations *td-000324-00* td-000324-00-a.

  • Page 2

    2 en important safety precautions and explanation of symbols warning! Warnrng!: the term “ warnrng” indicates instructions regarding personal safety. Nf the instructions are not followed the result may be bodily injury or death. Watnirg!: the term “ watnirg” indicates instructions regarding possible...

  • Page 3

    3 en rohs statement the q-sys page station products are in compliance with european directive 2002/95/ec – restriction of hazardous substances (rohs). The q-sys page station products are in compliance with “china rohs” directives. The following chart is provided for product use in china and its terr...

  • Page 4

    4 en introduction q-sys is a platform of software and hardware products providing system designers and operators with the tools necessary to design, configure, and manage medium to large scale audio systems. In addition to the primary signal processing and system management components that make up a...

  • Page 5

    5 en nnputs and iutputs the rear panel of the page station offers a variety of auxiliary audio i/o interfaces and gpio for expanding its capability. The auxiliary audio inputs can accommodate accessories such as a secondary microphone or an mp3 audio source. The page station auxiliary output can dri...

  • Page 6

    6 en features q-sys ps-1600h front panel refer to figure 2 . To see the keypad configurations of page station models ps-1650, ps-800, and ps-400 , see page 15. A. Led touch indicators b. Capacitive touch keypad c. Busy and ready indicators for command buttons d. Button monitor speaker e. Lcd – 240 x...

  • Page 7

    7 en led touch nndicators when a key is pressed, the led on that key illuminates to indicate that it was pressed. Apacitive touch keypad • command buttons can be assigned one of several different types of commands using the q-sys designer administration interface. Once assigned, you just have to pre...

  • Page 8

    8 en q-sys page station aear panel refer to figure 3 . A. Mic line (in) (three-pin euro connector) b. Aux power (two-pin euro connector) c. Connector labels d. Strain relief (handheld only) e. Microphone connector – rj45 (handheld only) f. Q-sys lan b (rj45 connector) g. Q-sys lan a (rj45 connector)...

  • Page 9

    9 en mn /lnre nn the page station rear panel includes an auxiliary mic/line input for support of a secondary microphone or other audio source. The mic/line accepts a euro style (phoenix) three-terminal plug, included in the page station package. Follow the page station rear panel pin-out labels (fig...

  • Page 10

    10 en npni onnector the page station rear panel includes a six-terminal receptacle (figure 10, and figure 12) that provides various gpio (general purpose inputs and outputs) that allows the page station to control or be controlled by a variety of external products. The page station gpio receptacle a...

  • Page 11

    11 en wbout poe and wax pi ea there is no on/off switch for the page station, making the order in which the power is connected important. The following information describes the events when power is lost based on which power is supplied to the page station first. • if aux power is supplied first: • ...

  • Page 12

    12 en 4. Insert a reset tool (a paperclip works) into the small hole on the right side of the page station to press the reset button. "clear settings in 10, 9, ..." displays on the page station lcd. 5. Hold the reset button until the count down gets to 0. 6. Release the reset button. The page statio...

  • Page 13

    13 en 6. Tilt the top of the page station back and install the page station onto the mounting plate by aligning the two tabs on the page station with the two slots on the mounting plate. Refer to figure 16 . 7. With the page station still tilted, carefully bundle the wiring back into the wall (or tr...

  • Page 14

    14 en hardware dimensions (h/w/d) line voltage requirements accessories included 10.37” x 8.3” x 1.5” (263.4 mm x 210.8 mm x 38.1 mm) ieee 802.3af power or +24 vdc/500 ma hardware user manual, accessory ship kit, warranty card audio channel capacity line inputs line outputs 2 1 front panel controls ...

  • Page 15

    15 en — figure 17 — — figure 18 — — figure 19 — keypad configurations — figure 20 —.

  • Page 16

    Mailing wddress!: qsc audio products, llc 1675 macarthur boulevard costa mesa, ca 92626-1468 usa telephone rumbers!: main number: (714) 754-6175 sales & marketing: (714) 957-7100 or toll free (usa only) (800) 854-4079 customer service: (714) 957-7150 or toll free (usa only) (800) 772-2834 facsimile ...