Summary of USA 1310
Page 1
23 u s a s e r i e s fpo user manual manuel de l’utilisateur bedienhandbuch manual del usuario ▼ usa 400 ▼ usa 900 ▼ usa 1310 rev. A *td-000061-00* *td-000061-00*.
Page 2
1 protection .............................................................. 17 protection schutzschaltungen protecciÓn limiter .......................................................................... 17 limiteur limiter limitador short circuit protection .......................................... ...
Page 3
2 erklärung der bildsymbole das blitzzeichen innerhalb eines gleichseitigen dreiecks warnt den benutzer vor nicht-isolierter, gefährlicher spannung im inneren des gerätes. Diese spannung ist hoch genug, um personen durch elektrischen schlag zu gefährden. Das ausrufungszeichen innerhalb eines gleichs...
Page 4
3 declaration of conformity we declare as our sole responsibility that this product is in compliance with the emc directive 89/336/eec and conforms to the requirements of the harmonized product standards en 55013 (product emissions), and en 55020 (product immunity). Korformitätserklärung wir erkläre...
Page 5
4 front panel of usa 400 or usa 900 front panel of usa 1310
Page 6
5 i n t r o d u c t i o n e i n f Ü h r u n g i n t r o d u c c i Ó n a v a n t- p r o p o s front panel 1. Power switch 2. Power leds 3. Clip led (channel 1) 4. Clip led (channel 2) 5a. Fuse holder (220–240 vac only) 5b. Circuit breaker (100 and 120 vac only) panel frontal 1. Interruptor de encendi...
Page 7
6 rear panel 1. Gain controls 2. Dip switch for parallel inputs, lim- iter, and high-pass filter 3. Input barrier strip 4. Output (channel 1) 5. Output (channel 2) 6. Inputs 7. Stereo/bridge mono switch 8. Ac mains cable panneau arrière 1. Commandes de gain 2. Bloc de commutateurs pour entrées paral...
Page 8
7 m o n t a g e avant utiliser quatre vis de montage. B e f e s t i g u n g vorn benutzen sie vier befestigungsschrauben. M o n t a j e frente utilice cuatro tornillos. M o u n t i n g front use four mounting screws. On ch2 power breaker usa900 profes sional amplifier ch1 clip.
Page 9
8 operating voltage (ac mains) the serial number label indicates the correct ac mains voltage. Connecting to the wrong voltage is dangerous and may damage the amplifier. Inputs the “combo” input connectors accept standard male xlr and 6.3 mm (1/4") trs connectors, both balanced and unbalanced. Tensi...
Page 10
9 outputs strip back insulation 13 mm. Sorties dénuder le fil sur 13 mm. Ausgänge kabel 13 mm abisolieren. Salidas aislamiento de la parte de atrás de la borna de 13 mm. Insert wire fully; tighten barrel (use coin if necessary). Insérer le fil complètement; serrer le corps du -connecteur (utiliser u...
Page 11
10 high-pass filter the high-pass filter removes ultra- low frequency information from the audio signal that could damage or cause distortion in a loudspeaker system. The dip switch on the rear panel allows you to enable or disable the filter independently for either channel, as well as set it for e...
Page 12
11 o p e r a t i o n configuring the amplifier an 8-position dip switch on the rear panel allows you to configure certain amplifier characteristics. A diagram on the rear panel shows the individual switch functions and settings. Positions 1 and 2: parallel inputs these two positions are for connecti...
Page 13
12 positions 3 and 6: limiter these two positions affect the clip limiter for channel 2 and channel 1, respectively. The “on” setting enables the limiter for that channel, while the “off” setting disables it. Positions 4, 5, 7, and 8: high- pass filter setting position 4 to “on” enables the high-pas...
Page 14
13 circuit breaker (100 and 120 vac amplifiers only) the circuit breaker is on the front panel next to the power switch. If the circuit breaker trips due to an ac current overload, reset it. If the breaker trips again quickly, have the amplifier checked by an authorized qsc service center. Sicherung...
Page 15
14 gain controls the gain controls are located on the rear panel and are calibrated in db of attenuation from full gain. Verstärkungseinstellung die verstärkungseinsteller befinden sich auf der rückseite und sind in db-absenkung gegenüber voller verstärkung kalibriert. Led indicators the green led i...
Page 16
15 parallel, stereo, and bridged mono eingangsparallelschaltung, stereobetrieb, und mono-brückenbetrieb estéreo, paralelo y mono puente connecting outputs stereo operation stereo/bridge switch modes parallèle, stéreo, et mono ponté (bridgé) opÉration en mode stÉreo sélecteur de mode stereo/bridge (s...
Page 17
16 bridged mono operation bridged-mono mode caution: output voltages as high as 110 volts rms are available between the usa 1310's bridged terminals. Fully insulated class one wiring must be used to connect the amplifier to the load, and the load must be rated up to 1200 watts (8 ohms). Models usa 4...
Page 18
17 p r o t e c t i o n limiter during normal operation, the limiter does not affect the audio signal and is, in fact, inaudible. It will allow brief clipping of peaks and will only activate when continuous, hard clipping occurs. The limiter will then reduce the audio signal enough to minimize the am...
Page 19
18 dc fault protection the outputs will mute if dc or excessive subsonic energy appears at them. Protection contre une anomalie cc les sorties seront coupées en présence de courant continu ou de signal subsonique excessif. Schutz gegen gleichspannung bei auftreten von gleichspannung oder übermäßigem...
Page 20
19 usa 400 usa 900 usa 1310 output power* both channels driven ftc: 20 hz-20 khz @ 0.1% thd 8 Ω per channel 110 240 375 eia: 1 khz @ 1% thd 8 Ω per channel 125 270 400 4 Ω per channel 200 450 655 2 Ω per channel 250 550 1000 bridged mono: 16 Ω , 1 khz, 1% thd 250 540 800 8 Ω , 1 khz, 1% thd 400 900 ...
Page 21
20 technische daten s p e c i f i c at i o n s s p É c i f i c at i o n s especificaciones usa 400 usa 900 usa 1310 amplifier protection full short circuit†, open circuit, thermal, ultrasonic, and rf protection stable into reactive or mismatched loads load protection limiting, subsonic filtering out...
Page 22
21 w a r r a n t y i n f o r m a t i o n (usa only; see your dealer or distributor) informations de g a r a n t i e (ee. Uu. Seulement; consultez votre marchand ou distributeur) garantie-nachricht (nur usa; in anderen ländern ihren fachhändler fragen) informaciÓn de g a r a n t Í a (ee. Uu. Solament...
Page 23
22 a d d r e s s & t e l e p h o n e i n f o r m a t i o n address: qsc audio products, inc. 1675 macarthur boulevard costa mesa, ca 92626-1468 usa telephone numbers: main number (714) 754-6175 sales direct line (714) 957-7100 sales & marketing (800) 854-4079 (toll-free in u.S.A. Only) customer serv...
Page 24
24 qsc audio products, inc. 1675 macarthur boulevard costa mesa, california 92626 usa.