QSC Weatherized WideLine Series User Manual

Summary of Weatherized WideLine Series

  • Page 1

    User manual wl2102-wx loudspeaker wl3082-wx loudspeaker gp218-wx subwoofer weatherized wideline series *td-000307-00* td-000307-00 rev. A.

  • Page 2

    1 2 important safety precautions and explanation of symbols warning! The lightning flash with the arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous” voltage within the product’s enclosure that may be of sufficient magnitude to con...

  • Page 3

    1 2 package contents wl2102-wx / wl3082-wx loudspeakers front outer rigging link - wl3082-wx (10.5 in., 267 mm) (p/n ch-000980-00) front outer rigging link - wl2102-wx (8.6 in., 219 mm) (p/n ch-000987-00) 2 2 front center front rigging link (p/n ch-000981-00) 2 m10 flat washer 4 m10 lock washer 4 ny...

  • Page 4

    3 4 wl2102-wx loudspeaker a. Suspension attachment screws (qty: 8) b. Suspension links c. Grille d. Splay angle selector holes e. 25" cable c – figure 3 – d a – figure 4 – b e gp218-wx loudspeaker a. Grille b. Non-slip feet c. 25" cable – figure 5 – – figure 6 – c a b.

  • Page 5

    3 4 af3082-wx and af2102-wx array frames a. Shackle holes (accept 5/8" (16 mm) screw pin anchor shack) b. Center support bar c. Suspension plate d. Rigging links e. Suspension attachment screws – figure 7 – c d b a e suspending the weatherized widelines rules for suspension • correct use of all susp...

  • Page 6

    5 6 weatherized wideline working load limits and design factors (table 1) lists the suspension components and provides working load limit data at various design factors. The tabulated design factors are for static loads only. The choice of which design factor to use will depend upon the jurisdiction...

  • Page 7

    5 6 2. Install the hardware listed below onto both rear corners of the loudspeaker as shown in (figure 9) . Hand-tighten only at this time. Assembly order a. Nylon spacer b. Rear suspension link (removed earlier) c. M10 flat washer (removed earlier) d. M10 lock washer (removed earlier) e. M10 hex so...

  • Page 8

    7 8 top or middle loudspeaker in the array 1. Place the next loudspeaker assembly on a flat, stable surface, remove the two cap screws, flat washers, and lock washers from both top-rear corners as shown. Place aside for later use. 2. Loosen the two bottom-rear cap screws and rotate the rear-center r...

  • Page 9

    7 8 assembling the array 1. Place the pre-assembled top or middle loudspeaker assembly on top of the bottom (or another middle) loudspeaker, aligning the rigging links with their respective rigging links on the bottom loudspeaker as shown below. 2. Secure the top loudspeaker to the bottom loudspeake...

  • Page 10

    9 10 assembling the array frame 1. Place the array frame on top of the top loudspeaker, aligning the rigging links with their respective rigging links on the top loudspeaker as shown below. 2. Secure the array frame to the top loudspeaker with two 70l / 50l cap screws in the rear, and two 70l / 50l ...

  • Page 11

    9 10 specifications wl3082-wx wl2102-wx gp218-wx configuration tri-amp only line-array tri-amp only line-array subwoofer transducers hf: 1.4" exit, 3" diaphragm, neodymium magnet compression driver lf: dual, 8" woofer, 2.5" voice coil hf: 1.4" exit, 3" titanium diaphragm, neodymium magnet assembly l...

  • Page 12

    11 12 dimensions wl3082-wx loudspeaker 20" 508 mm 9.5" 241.3 mm 15.5" 397 mm.

  • Page 13

    11 12 wl2102-wx loudspeaker 27.25" 692 mm 11.75" 298.5 mm 18.5" 469.9 mm.

  • Page 14

    13 14 gp218-wx subwoofer 47.32" 1201.8 mm 22.0" 560 mm 30" 765 mm.

  • Page 15

    13 14 af3082-wx array frame 8.0" 203 mm 21.1" 536 mm 7.06" 179.4 mm 3.8" 95 mm 18.1" 459 mm.

  • Page 16

    Mailing address: qsc audio products, llc 1675 macarthur boulevard costa mesa, ca 92626-1468 usa telephone numbers: main number: (714) 754-6175 sales & marketing: (714) 957-7100 or toll free (usa only) (800) 854-4079 customer service: (714) 957-7150 or toll free (usa only) (800) 772-2834 facsimile nu...