Qstarz BT-Q818 Quick Installation Manual

BT-Q818

 Super 51-CH Performance Bluetooth GPS Receiver 

BT-Q818 Quick Installation Guide 

Thank you for purchasing Qstarz BT-Q818 Super 51-CH Performance Bluetooth GPS Receiver. It 

provides 51-Channel All-In-View Tracking and 32 hours of navigation with Smart Power control for 

power saving. 

A. Standard Package 

GPS Unit BT-Q818 (1) + Lithium-ION Rechargeable Battery (2) + Cigarette Adapter (3) + Optional Travel Charger (4) + Warranty Card + 

Quick Installation Guide. 

(* Travel Charger plug type might be adjusted according to corresponding countries.)

1.                                              2.                                      3.                                                  4. (Optional)

B. Appearance 

1.    Power jack (mini USB type)   

2.  Power switch  

3.    Battery status LED (Red/Green)   

4.    Bluetooth status LED (Blue)   

5.    GPS status LED (Orange)   

6.  Internal antenna  

C. Battery installation

C-1 Put Battery in place:

  Press the 

PUSH

 button on the bottom side of the unit (1) and pull out the battery cover. Insert battery in the 

unit (2) and put battery cover on to the cabinet (3), then push down and force it forward to fit firmly (4). 

                          1.                                                        2.                                                            3.                                                            4. 

C-2 Take Battery out:

  Press the 

PUSH

 button on the bottom side of the unit (1) and pull out the battery cover (2). Then take out the 

battery from the unit (3).   

                    1.                                                              2.                                                            3.                                                                       

D. Charging your battery 

E. Start to use 

E-1    Activate the Bluetooth function in your PDA/Smart phone or PC 

Before activating the Bluetooth function in your PDA/PC, please switch on BT-Q818 Receiver for paring and check if your device is 

equipped with Bluetooth function. If not, you may need to acquire an optional CF/SD Bluetooth card or Bluetooth dongle. 

NOTE: The code is “

0000

” if required for the pairing in the first time. 

E-2    Automatically create a shortcut in Bluetooth Manager window

1

For the first time using the BT-Q818, please charge battery until it is fully 

charged. Take the power cable and connect it to the power jack (mini USB 

type) and recharge through travel charger or car cigarette adaptor. This will 

begin to charge the battery. Charging time is 3 hours typically. 

- When the Power LED is Red, battery power is low status. Please recharge. 

- When the Power LED is Green, the battery is under charging mode. 

- When the Power LED is blinking, the battery is fully charged.

1

６

２

４

３

５