Qstarz BT-Q910 Quick Installation Manual

BT-Q910

 Bluetooth GPS Receiver 

1 

BT-Q910 Quick Installation Guide 

Thank you for purchasing Qstarz BT-Q910 SiRF Star III Bluetooth GPS Receiver. It is the world’s 

longest 14 hours of navigation with SiRF Star III solution. 

Main features: 

z

Adopt SiRF Star III chipset 

z

20-Channel GPS Receiver for fast acquisition and reacquisition 

z

Ultra low power control: 14 hours usage / 1 week stand-by time 

z

High sensitivity (to -159dBm) 

z

Excellent performance - Cold/Warm/Hot start time: 42/38/1 sec. (average) 

z

Support standard NMEA-0183 at 38400 bps baud rate 

z

Compatible with Bluetooth Serial Port Profile (SPP) in 10m wirelessly 

z

Non-slip back pad for a secure placemen 

A. Standard Package 

GPS Unit BT-Q910 (1) + Lithium-Ion Rechargeable Battery (2) + Cigarette Adapter (3) + Travel Charger (4) + USB Cable (5) + Non-Slip 

Pad (6) Warranty Card + Quick Installation Guide. 

(* Travel Charger plug type might be adjusted according to corresponding countries.)

1.                                        2.                                      3.                                        4.                                        5.                                    6. 

B. Appearance 

C. Charging your battery 

For the first time using the BT-Q910, please charge battery until it is fully charged. Take 

the power cable and connect it to the power jack (mini USB type) and recharge through 

travel charger or car cigarette adaptor. This will begin to charge the battery. Charging 

me is 3 hours typically. 

ti

- When the Power LED is Green, battery power is low status. Please recharge. 

- When the Power LED is Orange, the battery is under charging mode. 

- When the Power LED is Off, the battery is fully charged.