Qtx BUSKER-12 User Manual

Summary of BUSKER-12

  • Page 1

    Busker portable pa units order ref: busker-12 (178.866uk) busker-15 (178.868uk) user manual version 2.0

  • Page 2

    Busker user manual caution: please read this manual carefully before operating damage caused by misuse is not covered by the warranty introduction thank you for choosing a busker portable pa unit. This versatile portable pa unit is packed with features in a compact, manageable enclosure and is suita...

  • Page 3

    Busker user manual front panel rear panel 1 vhf microphone indicators 2 vhf mic a volume 3 vhf mic b volume 4 usb port 5 led display 6 sd/mmc card slot 7 usb/sd/fm/bluetooth volume 8 media player mode select 9 playback repeat mode select 10 usb/sd memory device select 11 previous track (hold seek re...

  • Page 4

    Busker user manual powering up your new busker portable pa unit may arrive with you with the internal battery charged. Before connecting to the mains, turn down all volume controls and switch the unit on (30) and see if the power led lights (29). If not, you will need to charge the battery before us...

  • Page 5

    Busker user manual external inputs in addition to the busker ’s own vhf microphones, two 6.3mm jack inputs (20, 21) are provided to connect external wired or wireless microphones, which are both governed by the wired mic vol control (16). If required, the music level can be automatically muted when ...

  • Page 6

    Busker user manual fm tuner in fm tuner mode, the station frequency (in mhz) will be displayed. For initial setup, press play/pause to begin the auto-tuning process. The tuner will seek through all frequencies for strong signal reception (i.E. Radio stations) these will be stored into memory as , , ...

  • Page 7

    Busker user manual specifications model busker-12 busker-15 power supply 230vac, 50hz (iec) output power 80w 100w frequency response 50hz - 16khz 50hz - 16khz spl @ 1w/1m 94db 96db main driver 300mmØ (12“) 380mmØ (15“) impedance : loudspeaker 4 ohms hf driver : type compression driver wireless micro...

  • Page 8

    Busker user manual troubleshooting no output and no leds lit check power switch is on check battery is not drained fully check mains lead is connected check mains or d.C. Fuse hasn’t blown power led lit but no vhf output check 9v batteries in wireless transmitters check wireless transmitters are swi...