Qtx GOBO DERBY User Manual - page 4
151.603UK User Manual
Standalone operation
The GOBO DERBY can be operated without external control by selecting one of the Internal show modes
from the control panel menu. These are Shown in the Internal Settings section on the previous page.
Internal settings can also be selected via the included IR remote control as detailed below.
As supplied, the remote handset has a clear plastic tab inserted which should be removed to activate the
CR2025 button cell. Point the handset toward the front of the GOBO DERBY unit at a range of no more than
5m for remote control.
Master/slave operation
An GOBO DERBY fixture operating in one of the standalone modes may be connected by DMX lead to control
further GOBO DERBY units by pressing the MENU button until “” is displayed, pressing enter and
selecting “” to set it as the master unit
The slave units must be set to “” mode to mimic the operation of the master unit.
In this mode, the slave GOBO DERBY units will mimic the master GOBO DERBY working in standalone mode.
DMX operation
In order to access the DMX functions, the DMX start address will need to be set on the control panel (or
from the remote control as detailed above).
When the display shows “
”, this means that the GOBO DERBY is operated starting from DMX address 1.
When the display shows “
”, this means that the GOBO DERBY is operated starting from DMX address
203. The start address can be anywhere between 001 and 512.
There are 2 DMX modes – 2 channel and 10 channel – which are detailed on the following pages.
Standby
Temporarily disables light output
DMX
- Not used -
Show 1 – Show 4
Select internal show mode
Show 5 – Show 8
- Not used -
LED Color
LED colour select
LED Random
Random LED colour select
Laser Color
Laser colour select
Laser Random
Laser random LED colour select
Sound ON
Sound activation on
Sound OFF
Sound activation off (auto mode)
Speed -
Reduce effect speed
Speed
Default (medium) effect speed
Speed +
Increase effect speed