Qtx KAD-2 User Manual - page 3
103.122UK Manual
Series Connection - R
total
= R
1
+ R
2
+ R
3
…….
Installation:
Before installation, please ensure power is switched off and mains unpluged from the wall to avoid
damage to equipment and installer.
Wire speakers to the amplifier as shown above, ensure the positive and negative terminals are wired
correctly. Audio input on the back is through 3 pairs of RCA connectors, ensure left and right signals are
correct for stereo output. Finally insert the IEC plug and connect the unit to the mains. Before switching
on, always ensure the master volume is set at the lowest point to avoid power surge damage to the unit
or speakers. Adjust the volume accordingly to an appropriate listening level.
Media Player:
KAD-2BT has a built in media player which functions as an MP3 player, FM tuner and Bluetooth receiver.
To use turn the input selector to media player.
MP3 Player – MP3 files can be played through an SD card or USB stick. Plug in the memory device and
media will automatically start playing. Alternatively press Mode button until “USB” is displayed on the
screen. To make a selection, press VOL-/VOL+ for previous or next song respectively, to control input
volume press and hold VOL-/VOL+ for volume down and volume up respectively. For play and pause press
button.
Bluetooth – for bluetooth connection press MODE button until “BT” is displayed on the screen. From your
bluetooth search function (please refer to device manual for instructions) look for “KAD-2BT” to pair with,
you should hear a tone once successfully connected. To make a selection, press VOL-/VOL+ for previous
or next song, to control input volume press and hold VOL-/VOL+. For play and pause press button.
FM radio – for FM radio press MODE button until “FM” is displayed on the screen. Press the play and
pause button to intiate search function through FM frequencies, all searched radio stations will be