Qtx LOFOG-400 User Manual - page 3
160.444UK User Manual
Layout
1. Carry Handle
2. Fluid bottle
3. Top panel opening for ice reservoir
4. Fog output nozzle
5. Fluid drain plug
Rear panel
6. Remote control connection
7. Power ON/OFF switch
8. Rear fan vent
9. IEC mains inlet and fuse holder
Operation
Switch on the power switch on the rear panel.
Heat up time is usually around 3 minutes. Please do not press the remote button during the heat up time.
When the machine is ready the light on the remote control will illuminate
Press the remote button for 5 seconds so the fluid has a chance to flow through the heater block making it
ready to use.
After this you will be able to use the machine. It is recommended to produce smoke with small pauses in
between so that the temperature is maintained and the thermostat doesn’t switch off.
After use, drain the melted ice using the fluid drain tap on the rear panel.
Replacing the fuse
Disconnect from the main power supply first, then remove the fuse holder part of the IEC socket to reveal the
fuse. Replace the correct fuse rating as stated on the panel. Lock the fuse holder cover back into place.