Qtx QA100 User Manual - page 3
172.020UK/172.025UK User Manual
Connection:
Operation:
Check mains for correct voltage as indicated near to the IEC mains inlet on the rear panel. Connect to mains supply
using the IEC cable provided.
Connect the outputs A+B to speakers via speaker connectors, jack or binding posts, ensuring that the minimum
impedance is no lower than 4Ω per channel
When using 8Ω speakers, connect the speakers in pairs to each other and then connect one of each pair to an
amplifier channel output.
Connect the mixer or audio source to either the combo or RCA input sockets
With channel A+B levels down, switch the power on.
Gradually increase channel levels and check for sound from speakers.
If there is no sound, turn down channel levels, switch off and disconnect mains and check connections
– if front panel
PROTECT LEDs are lit, refer to qualified service personnel..