Qtx SC100 User Manual - page 4
178.192UK User Manual
Setting up
Remove the tripod stands from the carry bag and extend each tripod base so that the legs are
sufficiently spaced to support each speaker on a stable and even surface. Extend the upper telescopic
section to the required height.
Open the SC100 “suitcase” by unfastening the clips at either side of the handle and lifting the centre
console lid. With the lid opened fully, it is possible to lift out each of the 2 speakers, which should be
fitted to the top of the tripod stands.
Unzip the bag adjacent to the mixer-amp console and remove all accessories.
Connections
Connect the mixer-amp to both speakers using the included speaker jack leads (33, 34)
If required, connect the included microphone to channel 1 or 2 (22, 24) using the supplied XLR lead.
XLR sockets on channels 1 & 2 are for microphones, whereas the jack sockets (23, 25) are for mono
line inputs. Use either mic or line input, not both together into a single channel.
(Line input can be CD player, computer sound card, sub mixer etc.)
Channel 3 has a jack input (25) for mic or instrument (guitar, keyboard etc.) and another jack (26) for
line input.
Channel 4/5 is a stereo channel with 2 RCA sockets (27) for left and right line inputs.
If the stereo mix of all inputs is to be fed onto additional PA or recording equipment, there is a stereo
line output via RCA sockets (28) which should be linked to stereo line inputs of the external equipment.
There is also a mono line output (ideal for a wedge monitor) via a jack socket (29)
Finally, for monitoring the mix through headphones, there is a stereo phones jack output (30)
When all signal connections are completed, connect the IEC inlet (31) to a suitable mains supply using
the included power lead.
Initial settings
•
Set all faders (5, 7, 9, 20) to the zero mark (fully down)
•
Set all tone controls (6, 8, 10, 12) to the 12 o’clock position (vertical)
•
Set all Graphic EQ faders (14) to the zero mark (mid position)
•
Turn channel 4/5 rotary controls (4) to the zero mark (fully down)
•
Turn the EFFECTS and PHONES rotary controls to zero mark (fully down)
The SC100 PA is now ready to be switched on