Qtx UH5 User Manual - page 4
171.802UK, 171.803UK User Manual
In these circumstances, it may be better to move the transmitter switch to the “MUTE” position, which maintains the
radio frequency carrier signal but mutes the microphone input. When this switch is moved back to the “ON” position, the
sound will be immediately restored.
If the wireless system is not to be used for longer periods, it is preferable to slide the transmitter switch to the “OFF”
position, which mutes and deactivates the radio signal and powers down the transmitter. Be sure to turn down the
volume of the mixer or amplifier and then switch off the receiver. Unplug signal leads from the receiver and mixer or
amplifier when moving or packing away. If the system is not to be used for long periods of time, remove the batteries
from the transmitter and unplug the power adapter from the receiver and the mains outlet.
Specifications
Power supply - receiver
12-18Vdc, 350mA adaptor (included)
Power supply - transmitter
3Vdc (2 x AA batteries included)
Carrier frequency
864.99MHz
Maximum range
50.0m
Sensitivity
-105dB @ ±12dB
Signal to noise ratio
>105dB
THD
<0.5% @ 1KHz
Output connection
XLRF or 6.3mm jack
Frequency response
50Hz - 18KHz (±1dB)
Dimensions - handheld transmitter
265 x 46mmØ
Weight - handheld transmitter
174g (no battery)
Dimensions - bodypack transmitter
205 x 68 x 25mm
Weight - bodypack transmitter
76g (no battery)
Dimensions - receiver
209 x 150 x 42mm
Weight - receiver
390g
Troubleshooting
“POWER” LED does not light on receiver
Ensure power adapter is connected to mains and working properly
Ensure receiver is switched on
“POWER” LED is lit but no “SIGNAL” LED
Ensure transmitter is switched on
Check that transmitter is not out of reception range
Check that transmitter battery is good / charged
LEDs are lit but no sound from
microphone
Check if transmitter switch is in “MUTE” position
Make sure receiver is connected to mixer / amplifier
Make sure that amplifier / mixer channel volume is turned up
Ensure transmitter has a good / charged battery
Check if there is another nearby transmitter with the same frequency
Audio level from microphone is too high or
distorted
Turn down VOLUME on receiver
Reduce Gain on mixer / amplifier
Decrease bodypack gain control
Ensure that XLR output is not fed to a Line input
Audio level from microphone is very quiet
Turn up VOLUME on receiver
Increase Gain on mixer / amplifier
Ensure that Jack output is not fed to a Mic input
Increase bodypack gain control
Check transmitter battery
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
1622
Errors and omissions excepted.
Copyright© 2014. AVSL Group Ltd.