Quad195 quad195d multi-channel wireless system with rf/power distribution operating instructions and trouble-shooting guide lectrosonics, inc. Rio rancho, nm.
2 quad195/d introduction the design of lectrosonics quad pak systems has evolved over the years as a result of suggestions garnered during many conversations with industry sound mixers and production engineers. These suggestions, together with meticulous attention to de sign and construction detail...
3 multi-channel wireless system general technical description the quad195 consists of two sub-systems; the housing which contains the gel-cell power supply and the rf/power distribution module/s. The housing is constructed of machined aluminum. A strap handle is bolted directly to the top panel of t...
4 quad195/d antenna leads - these bnc terminated leads provide isolated rf signals for each receiver installed in the sys tem. Antenna - the helical antenna provided with the unit attaches to this bnc connector directly with a twist lock mo tion. Other 50 ohm antennas may also be used. Power switc...
Multi-channel wireless system rear panel description serial/frequency label - this label indicates the serial number of the distribution module. It also indicates the rf pass-band of the unit. Important - the receivers installed in the unit must fall between the frequencies indicat ed on the label....
6 quad195/d the quad195 is designed to contain up to four receivers. Installation of these receivers is quite simple. First, loosen but do not remove, the two large counter-sunk phillips head screws in the front panel and the two in the rear panel of the housing. (see drawings on previous pages) ins...
7 multi-channel wireless system symptom possible cause no power leds or audio 1) power switch in the off position. Switch to main/ext. Power led lights on cdm4 smt 1) power leads in back not connected to receivers. But no lights on receivers check power connections. No power leds, all 1) gel-cell ba...
8 quad195/d rf gain: 1.5 db rf output: four outputs, 50 ohm, bnc filtering: two section helical resonator third order intercept: +25 dbm power input: 12 to 20 vdc (either polarity) pins 1 and 4 on xlr power jack ch-50 adapter for ac operation 14 to 20 vac, 50/60 hz, 1/2 amp pins 2 and 3 on xlr power...
9 multi-channel wireless system we strongly recommend that you do not try to repair the equipment yourself and do not have the local repair shop attempt anything other than the simplest repair. If the repair is more complicated than a broken wire or loose connec tion, send the unit to the factory f...
Limited one year warranty the equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was purchased from an authorized dealer. This warranty does not cover equipment which has been abused or damaged by careless handling or shipping. This warr...
