QUAD FORUM - REV 1 Instruction Booklet - page 6
INSTALLATION
Carefully unpack the contents of the shipping carton and verify
that all of the mounting hardware is accounted for. The supplied
hardware will support three types of installation as detailed below:
Wall or Pole Mounting
This method allows mounting of the loudspeaker to any suitable
vertical surface such as a wall or pole.
Step 1
Remove the mounting yoke from the loudspeaker by removing the
bolts on the top and bottom of the enclosure.
Step
Mount the bracket to the mounting surface using suitable fasteners
through the pre-drilled holes in the bracket’s spine.
Step
Place the loudspeaker into the yoke bracket and re-insert the
mounting bolts, taking care to make them snug, without over tight-
ening. Use of thread locking compound is recommended.
3-POINT HANGING
This method allows the suspension of the loudspeaker from a truss
or building structure using stranded safety cable or suitably rated
chain securely attached to three points on the cabinet using the
supplied brackets and hardware.
Step 1
Remove the bolt holding the mounting yoke to the top of the cabi-
net and install the suspension adapter as shown. Tighten the bolt
taking care not to over tighten. Use of thread locking compound is
recommended.
DIMENSIONS
Forum 12SUB
195mm/7.7”
750mm/29.5”
850mm/33.5”
Forum 15SUB
220mm/8.7”
Forum 15XB
Forum 18XB
440mm/17.33”
610mm/24”
610mm/24”
522mm/20.6”