Quadelectra Audioworx Jackbox 7R-707 Operation Manual - 2. Front Panel
Operation Manual
Page 4
2. Front Panel
The front panel in both devices, is separated in two parts:
Fig2a: An abstract look to the front panel of both 7R-707 & 7R-727 devices.
A. Drum Pads: The drum pads give you immediate access to the drum
sounds of the device. Following the original hardware, the Closed Hi
Hat (HC) in 707 and Short Whistle (SWHIS) in 727 have two dedicated
trigger buttons.
B. Level Faders: There are three types of level faders that the device
uses to control various parameters
a. Accent Fader: Found in the leftmost of the fader section, the
Accent Fader defines the amount of Accent to use when the
Accent automation switch is enabled. Note that "Accent"
applies only when playing the drum pads.
The device will use the value of CV Gate In signals and the
velocity from MIDI events, to determine the strength (velocity)
of the hit.
More information on the Gate Inputs, are provided at Chapter
3 of this manual.
Moreover you can find the drum set MIDI key mapping for each
device at APPENDIX I, of this manual.
b. Main Volume: This is found at the rightmost of the fader
section. Controls the volume of the entire device.
The main volume control setting does not affect the volume on
drums that run through their dedicated outputs.