QuadLink XC-QL4-K2 Quick Start Instruction Manual - page 2

This Quick Start Instruction Manual is designed to help you quickly set up 

and use your 8-Station QuadLink Kit correctly. It is not intended to serve as a 

replacement for the product manuals themselves.

(1)  Turn off engine if battery is still connected.

(2)   Take the battery tester and remove the black negative (- NEG) probe from the tester 

(Fig. 1)

(3)   Touch the red positive (+POS) probe to the (+) battery post.

(4)   Then touch the black negative (-NEG) probe to the negative battery post.

(5)   The battery tester’s LED will indicate the battery’s state of charge (100%, 75%, 50% or 25%.)

(6)   If battery state of charge is 75%, 50%, or 25% go to step 7. If state of charge is 100%  go to step  

12. 

All batteries should test at 100% prior to being connected to the QuadLink(s).

(7)   Connect the battery charger’s 2-pin output connector to the 2-pin input connector of either the   

battery clips or lugs. 

(Fig.2) 

(8)   Attach the red positive (+POS) battery clip or lug to the (+) battery post.

(9)   Attach the black negative (-NEG) battery clip or lug to the (-) battery post.

(10)  Plug battery charger into 110-220 VAC  power source.

(11)  Charge battery until it’s fully charged. This is shown by the green “100%” LED illuminating.

(12)  Connect your battery charger’s 2-pin output connector to the 2-pin input connector of the  

QuadLink. (Fig.2)

(13)  Connect the QuadLink 2-pin output connector to the 2-pin input connector of either the battery   

lead with lugs or battery lead with clips. 

(14)  Connect the lugs or clips to the battery. Be sure to first connect the red battery clip or lug to the  

(+) battery terminal. Then connect the black battery clip or lug to the (-) battery terminal.

(15)  Repeat as necessary for up to 8 batteries.

(16)  Once all cable leads have been connected to all the batteries, plug battery charger into 110-220  

VAC power source.

(17)  Your 8-Station QuadLink Kit can remain connected indefinitely without danger of overcharging    

or overheating. Continued use will ensure existing sulfates on the battery plates are eliminated   

and will prevent new sulfate crystals from forming allowing your battery to charge deeper,  

maintain greater reserve capacity and last longer.

X2-QL4-K2, 8-Station QuadLink Kit 

Quick Start Instruction Manual

Fig. 1

Fig. 1

998XM206 05/13