1. DL manuals
  2. Quadra-Fire
  3. Wood stove
  4. EXPLR-I-MBK
  5. Owner's Manual

Quadra-Fire EXPLR-I-MBK Owner's Manual

Other manuals for EXPLR-I-MBK: Installation Manual

Summary of EXPLR-I-MBK

  • Page 1

    1 7062-196b february 25, 2016 explr-i-mbk explr-i-pbk explr-i-pdb explr-i-pft explr-i-pmh explorer i model(s): o-t l tested and listed by portland oregon usa omni-test laboratories, inc. C us notice: do not discard this manual owner’s manual operation & care installer: leave this manual with party r...

  • Page 2

    2 7062-196b february 25, 2016 explorer i b. Sample of serial number / safety label location: back of appliance room for .14 x .875” s/n 1.5” x .375 barcode label spÉcifications de la ventilation: mur simple: de six (6 inches) (152mm) de diamètre le connecteur de conduit de minimum d'acier noir ou bl...

  • Page 3

    February 25, 2016 7062-196b 3 explorer i table of contents safety alert key: • danger!Indicates a hazardous situation which, if not avoided will result in death or serious injury. • warning! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • caution!Indi...

  • Page 4

    4 7062-196b february 25, 2016 explorer i x molded refractory panels hearth & home technologies limited lifetime warranty hearth & home technologies, on behalf of its hearth brands (“hht”), extends the following warranty for hht gas, wood, pellet, coal and electric hearth appliances that are purchase...

  • Page 5

    February 25, 2016 7062-196b 5 explorer i warranty conditions: • this warranty only covers hht appliances that are purchased through an hht authorized dealer or distributor. A list of hht authorized dealers is available on the hht branded websites. • this warranty is only valid while the hht applianc...

  • Page 6

    6 7062-196b february 25, 2016 explorer i d. Quick start guide note: these are generic drawings and may not represent your specifi c model. Burn rate control adjust air control set to desired heat output the appliance is ready for normal operation. 2 3 6 items needed for first fire: load wood add new...

  • Page 7

    February 25, 2016 7062-196b 7 explorer i the quadra-fire explorer i meets the u.S. Environmental protection agency’s 2015 particulate emission standards. Model: explorer i laboratory: omni test laboratories inc. Report no: 0061ws091s type: safety standard: ul 1482-11 & 737-11; ulc s627-00 this appli...

  • Page 8: User Guide

    8 7062-196b february 25, 2016 explorer i user guide 2 operating instructions 1. Symptoms of over-firing symptoms of over-fi ring may include one or more of the following: • chimney connector or appliance glowing • roaring, rumbling noises • loud cracking or banging sounds • metal warping • chimney f...

  • Page 9

    February 25, 2016 7062-196b 9 explorer i figure 9.1 burn rate control acc control figure 9.2 fl ames tend to go out, the air control it is set too low for your burning conditions. The air control located below the ash lip is used to adjust for burn rates. This is called the burn rate air control. Fi...

  • Page 10

    10 7062-196b february 25, 2016 explorer i g. Building a fire before lighting your fi rst fi re in the appliance: 1. Confi rm the baffl e is correctly positioned. It should be even with the front tube and resting on all tubes. Figure 11.1 and 11.2 on page 11. 2. Remove all labels from glass and insid...

  • Page 11: Incorrect Positions

    February 25, 2016 7062-196b 11 explorer i incorrect positions h. Correct baffl e & blanket placement ceramic blanket and baffl e board are not in contact with the back of the fi rebox. Ceramic blanket is not in contact with the back of the fi rebox and not even with the baf- fl e board in the front....

  • Page 12

    12 7062-196b february 25, 2016 explorer i i. Blower operating instructions note: if your quadra-fire wood appliance is equipped with an optional blower, you should follow these guidelines: 1. Initial (cold) start-up and all burn settings the blower can be plugged in and turned on right away. The blo...

  • Page 13

    February 25, 2016 7062-196b 13 explorer i negative pressure results from the imbalance of air avail- able for the appliance to operate properly. It can be strongest in lower levels of the house. Causes include: • exhaust fans (kitchen, bath, etc.) • range hoods • combustion air requirements for furn...

  • Page 14

    14 7062-196b february 25, 2016 explorer i baffl e & blanket optional blower chimney system firebrick & ash removal door & glass assemblies door handle frequency monthly, after every cord of wood, or after each cleaning baffl e and blanket placement is critical to heat out- put, effi ciency and overa...

  • Page 15

    February 25, 2016 7062-196b 15 explorer i b. Creosote (chimney) cleaning • frequency: every 2 months during heating season or as recommended by a certifi ed chimney sweep; more frequently if chimney exceeds or is under 14-16 ft. (measured from bottom of appliance) • by: certified chimney sweep remov...

  • Page 16

    16 7062-196b february 25, 2016 explorer i e. Glass cleaning • frequency: as desired • by: homeowner clean glass with a non-abrasive glass cleaner. Abrasive cleaners may scratch and cause glass to crack. If the deposits on the glass are not very heavy, normal glass cleaners work well. Heavier deposit...

  • Page 17

    February 25, 2016 7062-196b 17 explorer i with proper installation, operation, and maintenance your wood appliance will provide years of trouble-free service. If you do experience a problem, this troubleshooting guide will assist you or a qualifi ed service person in the diagnosis of a prob- lem and...

  • Page 18

    18 7062-196b february 25, 2016 explorer i handle glass assembly with care. When cleaning glass: • avoid striking, scratching or slamming glass. • do not clean glass when hot. • do not use abrasive cleaners. • use a hard water deposit glass cleaner on white fi lm. • use commercial oven cleaner on hea...

  • Page 19

    February 25, 2016 7062-196b 19 explorer i figure 19.3 figure 19.1 c. Snap disc replacement (included with optional blower) 1. Unplug the appliance. 2. Locate the snap disc bracket assembly at the bottom left rear corner of the appliance. 3. A magnet holds the bracket to the appliance. Pull the brack...

  • Page 20

    20 7062-196b february 25, 2016 explorer i f. Tube channel assembly replacement removing tube channel assembly 1. Remove convection blower shroud (4 screws, 2 on each side. A. Tilt shroud forward and slide up and away from appli- ance. 2. Remove right side casting. A. Caution: block up right side of ...

  • Page 21

    February 25, 2016 7062-196b 21 explorer i date of service performed by description of service a. Service & maintenance log 6 reference materials.

  • Page 22: Explorer I

    22 7062-196b february 25, 2016 explorer i service parts explorer i beginning manufacturing date: nov 2015 ending manufacturing date: active r wood stove part number list on following page. 02/16 color sku no. Mfg. Dates matte black explr-i-mbk 11/15- porcelain black explr-i-pbk 11/15- porcelain dark...

  • Page 23: Explorer I

    February 25, 2016 7062-196b 23 explorer i service parts explorer i beginning manufacturing date: nov 2015 ending manufacturing date: active r important: this is dated information . Parts must be ordered from a dealer or distributor. Hearth and home technologies does not sell directly to consumers . ...

  • Page 24: Explorer I

    24 7062-196b february 25, 2016 service parts explorer i beginning manufacturing date: nov 2015 ending manufacturing date: active r important: this is dated information . Parts must be ordered from a dealer or distributor. Hearth and home technologies does not sell directly to consumers . Provide mod...

  • Page 25: Explorer I

    February 25, 2016 7062-196b 25 service parts explorer i beginning manufacturing date: nov 2015 ending manufacturing date: active r important: this is dated information . Parts must be ordered from a dealer or distributor. Hearth and home technologies does not sell directly to consumers . Provide mod...

  • Page 26: Explorer I

    26 7062-196b february 25, 2016 service parts explorer i beginning manufacturing date: nov 2015 ending manufacturing date: active r important: this is dated information . Parts must be ordered from a dealer or distributor. Hearth and home technologies does not sell directly to consumers . Provide mod...

  • Page 27

    February 25, 2016 7062-196b 27 explorer i date note c. Home owner notes.

  • Page 28

    28 7062-196b february 25, 2016 hearth & home technologies 1445 north highway colville, wa 99114 division of hni industries do not discard this manual caution • important operating and maintenance instruc- tions included. • leave this manual with party responsible for use and operation. • read, under...