Quadra-Fire Grand Bay 40 Installation, Operation, Venting And Maintenance Instructions - Lighting Instructions
Grand Bay 40 Direct Vent Freestanding
Page 33
January 2000
LIGHTING INSTRUCTIONS
(LOCATED BEHIND PEDESTAL ACCESS DOOR)
FOR YOUR SAFETY READ BEFORE LIGHTING
A.
This appliance has a pilot that must be lit by hand. When lighting the pilot, follow these instructions
exactly.
B.
BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
· Do not try to light any appliance.
· Do not touch any electric switch; do not use any phone in your building.
· Immediately call your gas supplier from a neighbors phone. Follow the gas
suppliers instructions.
· If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push
in or turn by hand, dont try to repair it. Call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas control
that has been under water.
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information prior to this section.
2.
If using a thermostat, set the thermostat to the lowest setting. Pull down the grill on appliance front to
expose the control panel, and turn the ON/OFF switch to OFF.
3.
Turn off all electric power to the appliance.
4.
Open glass front.
5.
Push in gas control knob slightly and turn clockwise to OFF.
NOTE: Knob cannot be turned from PILOT to OFF unless knob is pushed in slightly. Do not force.
6.
Wait five (5) minutes to clear out any gas. Then smell for gas including near the floor. If you smell gas,
STOP! Follow B of the safety information in the section prior to this. If you dont smell gas, go to the
next step.
7.
Turn knob on gas control counterclockwise to PILOT.
8.
Push in control knob all the way and hold in. Immediately light the pilot by repeatedly depressing the
piezo igniter until a flame appears.
NOTE: The pilot should be visible through the door glass in the lower left hand corner between the
front and rear logs. As piezo igniter is depressed a blue spark can be seen. When lit, the flame will be
visible.
Continue to hold the control knob in for about thirty (30) seconds after the pilot is lit. Release knob and
it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 8.
· If the knob does not pop up when released, stop and immediately call your
service technician or gas supplier.
· If the pilot will not stay lit after several tries, turn the gas control knob to OFF
and call your service technician or gas supplier.
9.
Close glass front.
10.
Turn gas control knob counterclockwise to ON.
11.
If you are not using a thermostat, turn ON/OFF switch to ON. If you are using a thermostat, leave the
switch in the OFF position and set thermostat to desired setting.
TO TURN OFF GAS TO APPLIANCE
1.
If using a thermostat, set it to lowest setting.
2.
Turn off all electric power to the appliance if service is to be performed.
3.
Pull down grill on front of appliance to expose control panel.
4.
Push in gas control knob slightly and turn clockwise to OFF. Do not force.
5.
Close grill.
LIGHTING