Quadra-Fire YOSEMITE-MBK Installation & Operation Manual

Other manuals for YOSEMITE-MBK: Owner's manual, Owner's manual, Owner's Manual
Manual is about: Yosemite Non-Catalytic, Front/Side Load, Wood Heater

Summary of YOSEMITE-MBK

  • Page 1

    Save these instructions www.Quadrafire.Com this manual contains instructions for installation, operation & maintenance. Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. Yosemite ...

  • Page 2: Caution:

    R page 2 7004-187f september 1, 2008 yosemite wood stove and welcome to the quadra-fire family ! H earth & home technologies welcomes you to our tradition of excellence! In choosing a quadra-fire appliance, you have our assurance of commitment to quality, durability, and performance. This commitment...

  • Page 3: Table of Contents

    Page 3 yosemite wood stove 7004-187f september 1, 2008 r serial number label location .....................2 pre-use checklist ..............................................3 listings & safety notices ...............................4 installations material needed for safety 4 dimensions & vent speci...

  • Page 4

    R page 4 7004-187f september 1, 2008 yosemite wood stove listings and safety notices warning ! Do not attempt to operate this woodstove without reading and understanding these operating instructions thoroughly. Failure to operate this appliance properly may cause a house fire. Warning! Never draw ou...

  • Page 5

    Page 5 yosemite wood stove 7004-187f september 1, 2008 r dimensions front view side view vent specifications: single wall: measures 6 inch (152mm) diameter, minimum 24 msg black or blued steel connector pipe, with a listed factory-built chimney type ul103 ht* suitable for use with solid fuels, or a ...

  • Page 6

    R page 6 7004-187f september 1, 2008 yosemite wood stove b a c1 non-fuel door side d2 fuel door side c2 d1 clearances to combustibles (ul and ulc) g h e1 e2 f1 f2 fuel door side non-fuel door side g g* max mantel depth 10" (254mm) if side fuel loading door is not used: • it must remain in the locked...

  • Page 7

    Page 7 yosemite wood stove 7004-187f september 1, 2008 r floor protection the floor must be non-combustible material, extending beneath heater and to the front/sides/rear as indicated. The floor must be non-combustible or otherwise adequately protected from radiant heat given off by the unit and from ...

  • Page 8

    R page 8 7004-187f september 1, 2008 yosemite wood stove side fuel door locked shut - corner 26-3/4" 44-3/4" required coverage 16" 36-3/4" optional coverage optional coverage optional coverage 33.0" 8" front fuel loading door usa installations 44-3/4" both fuel doors accessible- corner 16" 16" 36-3/...

  • Page 9

    Page 9 yosemite wood stove 7004-187f september 1, 2008 r when locating your stove consider safety, convenience, traffic flow, and the fact that the stove will need a chimney and chimney connector. It is a good idea to plan your installation on paper, using exact measurements for clearances and floor pr...

  • Page 10

    R page 10 7004-187f september 1, 2008 yosemite wood stove converting collar for rear vent installation 1. Lift off cast top. Remove 4 phillips head screws from the heat shield. Discard heat shield and save the screws. Figure 10a 2. Remove 4 phillips head screws from the rear shield, 2 on each side, ...

  • Page 11

    Page 11 yosemite wood stove 7004-187f september 1, 2008 r to be sure that your stove burns properly, the chimney draft (static pressure) should be approximately -.04” water column (w.C.) during a low burn and -.10” w.C. During a high burn, measured 6 inches” (152mm) above the top of the stove after ...

  • Page 12

    R page 12 7004-187f september 1, 2008 yosemite wood stove thimble assembly: 12" (305mm) of brick separation between clay liner and combustibles. Fireclay liner 5/8" (16mm) minimum or equivalent. Sill support header wood stud 2" (51mm) clearance from chimney wall fireclay liner 5/8" (16mm) minimum or...

  • Page 13

    Page 13 yosemite wood stove 7004-187f september 1, 2008 r figure 13b solid pack chimney with metal supports as a thimble add the 19-5/16" (491mm), center-line measurement to the depth measurement of your floor protector. Mark this combined measurement at the correct wall location for your installatio...

  • Page 14

    R page 14 7004-187f september 1, 2008 yosemite wood stove 6 support plate & clamp listed rigid stainless liner stainless steel flex section stainless connector pipe carry stovepipe above the liner damper plate is removed or fastened in open position use damper adapter or seal with sheetmetal and sea...

  • Page 15

    Page 15 yosemite wood stove 7004-187f september 1, 2008 r when a metal prefabricated chimney is used, the manufacturer’s installation instructions must be followed precisely. It will be necessary to install the ceiling support package or wall pass through, “t” section package, firestops (when needed)...

  • Page 16

    R page 16 7004-187f september 1, 2008 yosemite wood stove spark arrestor cap roof flashing storm collar joist shield & firestop listed chimney connector floor protector outside air kit connector outside air floor vent 1. An outside air inlet must be provided for combustion and must remain clear of l...

  • Page 17

    Page 17 yosemite wood stove 7004-187f september 1, 2008 r items needed for installation: 4 inch (102mm) diameter flex pipe in the length as required for your installation; phillips screwdriver; silicone sealant; drills and saws necessary for cutting holes through the wall or flooring in your home. Inc...

  • Page 18: Warning

    R page 18 7004-187f september 1, 2008 yosemite wood stove burning process in recent years there has been an increasing concern about air quality. Much of the blame for poor air quality has been placed on the burning of wood for home heating. In order to improve the situation, we at quadra-fire have ...

  • Page 19

    Page 19 yosemite wood stove 7004-187f september 1, 2008 r final stage the final stage of burning is the charcoal stage. This occurs when the flammable gases have been mostly burned and only charcoal remains. This is a naturally clean portion of the burn. The coals burn with hot blue flames. It is very ...

  • Page 20

    R page 20 7004-187f september 1, 2008 yosemite wood stove *note: these are approximate settings, and will vary with type of wood or chimney draft. Due to altitude and other environmental circumstances, this operation information is a guideline only. Similar burn rates may be obtained using other set...

  • Page 21: Warning

    Page 21 yosemite wood stove 7004-187f september 1, 2008 r correct position incorrect positions firebox damage due to improper baffle place- ment is not covered by warranty. Operate the wood burning appliance with the baffle in the correct position only. Not doing so could result in: • reduced efficienc...

  • Page 22

    R page 22 7004-187f september 1, 2008 yosemite wood stove wood selection and storage caution: do not store wood closer than the required clearance to combustibles of the stove within the space required for fueling and ash removal burn only dry seasoned wood! This will not only minimize creosote form...

  • Page 23

    Page 23 yosemite wood stove 7004-187f september 1, 2008 r chimney cleaning 1. Remove all ash from the firebox and extinguish all hot embers before disposal. Allow the stove to cool completely. 2. Disconnect flue pipe or remove baffle from stove before cleaning chimeny. Otherwise residue can pile up on ...

  • Page 24

    R page 24 7004-187f september 1, 2008 yosemite wood stove 1 . Ensure that the fire is out and the stove is cool to the touch. 2. Protect a table or counter top with padding or towels. 3. Remove door with broken glass by lifting door up and off of the hinges. 4. Lay door face down on a table or counte...

  • Page 25

    Page 25 yosemite wood stove 7004-187f september 1, 2008 r maintenance 6 1 1 2 3 3 3 3 5 4 4 4 4 4 4 brick replacement instructions brick set part number: brick-7004 the firebox of your stove is lined with high quality firebrick which has exceptional insulating properties. There is no need for a grate,...

  • Page 26

    R page 26 7004-187f september 1, 2008 yosemite wood stove service & maintenance log date of service performed by description of service.

  • Page 27

    Page 27 yosemite wood stove 7004-187f september 1, 2008 r 3 4 7 8 11 12 15 16 1 2 5 6 10 13 14 17 9 17.0" 5-1/2" 21.0" 12-1/2" 2.0" ceramic blanket exploded views * part number list on following page. Item part name 1 air deflector 2 door hinge bracket 3 glass 4 hinge pin 5 washer 5 4 side door assem...

  • Page 28: Service Parts

    R page 28 7004-187f september 1, 2008 yosemite wood stove item # part description alphabetical order sku air deflector 7004-181 ash removal door assembly srv7004-006 17 ash lip, front see page 29 4 ash lip, side see page 29 ash pan 7004-155 7 back shield 7004-144 12 baffle, fiber baffle-7004 11 blanke...

  • Page 29: Service Parts

    Page 29 yosemite wood stove 7004-187f september 1, 2008 r latch, magnet 229-0631 leveling bolts & nuts 7000-000 manifold clip/screws (4) 832-0661 14,16 manifold tubes (3) tubes-7004 paint, touch-up, matte black 7000-304 paint, touch-up, porcelain crème 855-0390 paint, touch-up, porcelain green 855-0...

  • Page 30: Warranty Policy

    R page 30 7004-187f september 1, 2008 yosemite wood stove hearth & home technologies limited warranty hearth & home technologies (“hht”) and its respective brands extends the following warranty for hht gas, wood, pellet and electric appliances purchased from an authorized hht dealer and installed in...

  • Page 31

    Page 31 yosemite wood stove 7004-187f september 1, 2008 r noise resulting from minor expansion, contraction, or movement of certain parts is normal and complaints related to this noise are not covered by this warranty. Hht’s obligation under this warranty does not extend to damages resulting from: (...

  • Page 32: Your Records For Model:

    Page 32 7004-187f september 1, 2008 r • do not discard this manual. • important operating and maintenance instructions included. • read, understand and follow these instruci- tons for safe installation and operation. • leave this manual with party responsible for use and operation. Caution this prod...