Qualcast CDB30 Assembly Manual - page 4
6
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Step 2
Assembly
2a. Hold the top and bottom clamp snugly in position on the shaft housing so that handle will be
located to the operator’s left .
2b. Insert the end of the handle between the clamps.
2c. Align the bolt holes and push the long bolt through the handle side.
2d. Place short bolt through opposite side of clamp. Install flat washer, lock washers and hex nuts
to hold the assembly in place.
2f. After assembly is complete, adjust the position of the handle for best balance and comfort.
2e. Tighten the long bolt first and then the short bolt.
Step 3
Attach the curved shaft grass guard by snapping the guard around the shaft so it locates with the
bracket. Fix in place by inserting the bolts through the guard and bracket and tighten up.