Qualcast CHT18LA1 Assembly Manual - page 19
Customer Helpline
0344 801 0979
19
ORIGINAL INSTRUCTIONS
Technical Data
Technical Data Table
Charger voltage
100-240V~ 50-60Hz 0.8Amax
Voltage
18V
No load speed
1100/min
Cutting diameter
16mm
Cutting length
510mm
Battery capacity
2.0Ah
Full charging time
3-5hrs
Weight
2.1kg
Noise And Technical Date
A weighted sound pressure
76dB(A) KpA: 3.0dB(A)
A weighted sound power
87.2dB(A)
Guaranteed sound power level
90dB(A)
Wear ear protection when sound pressure is over
80dB(A)
Typical weighted vibration:
2.5m/s
2
, K:1.5m/s
2
The declared vibration value has been measured in accordance with a standard test method and may be
used for comparing one product with another.
The declared vibration value may also be used to evaluate the exposure for the user caused by vibration in
advance.
WARNING: The vibration emission value during actual use of the power tool can differ from the
declared value depending on the ways in which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use should also
take account of all parts of the operating cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This may significantly reduce the exposure level over
the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti vibration accessories.
Avoid using tools in temperatures of 10
0
C or less.
Plan your work schedule to spread any high vibration tool use across a number of days