Qualcast HST-1003A Assembly Manual - page 4
7
6
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Step 2 - Fitting the front wheel
Assembly
Screw the front wheel unit (B) to the machine (C) with the hexagonal bolt and nut as shown.
Pull the front wheel from its rest position. Attach the tension spring (D).
Step 3 - Fitting the draw bar
Assembly
Step 4 - Fitting the handle bar support
Hold the handle bar support (K) on the frame.
Tighten four hexagonal bolts with washers.
Pull out the securing splint (E) and the pin (F).
Insert the draw bar (G) into the main plate (H).
Insert the pin and secure it with the R/clip (E).
Step 5 - Fitting the steering handles
Hold both steering shafts at the side of the device, and insert two hexagonal bolts with washers into
each.
Tighten the hexagonal bolts.
Fit the steering cover on and screw it on tightly with four tapping screws.
NOTE! Make sure the clutch control lever (L) is at your right hand side when you stand behind the
unit.
B
C
D
E
G
H
F
K
I
J
L