Summary of C33R
Page 1
C33r repeater user manual.
Page 2
Getting to know your repeater led indicator status: off = power supply is off blue (double flash) = repeater in use with good signal red/blue = in registration mode purple (steady) = weak link to telephone base station blue (triple flash) = registration completed successfully purple (double flash) =...
Page 3
Setting up connect the mains power adaptor plug the small end of the power adaptor cable into the socket on the back of the repeater. Then plug the other end into the mains wall socket but don’t switch the power on at the wall socket yet. Use a power socket close to your telephone base station. This...
Page 4
Automatic registration to the telephone base station 1. Before beginning registration, make sure that all unregistered repeaters are switched off. 2. Turn on the repeater mode in the telephone base station that you will be registering the repeater to. This varies dependant on the product, the instru...
Page 5
Manual registration (optional) you can also register the repeater manually if you prefer. 1. Before beginning registration, make sure that all unregistered repeaters are switched off. 2. Turn on the repeater mode in the telephone base station that you will be registering the repeater to. This varies...
Page 6
Wall mounting the repeater (optional) the unit may be left free standing or mounted on a wall. See diagram below for reference only. The screws should be fixed at 92mm apart horizontally. Warning qualitel transmission recommends that you seek advice from a building professional before attempting to ...
Page 7
Using your qualitel dect repeater location tips: • place as high as possible, at least 1.8 meters off the ground • place 1 meter from sources of electrical interference such as hi-fi systems, office equipment microwaves, computers and routers • avoid heat sources and direct sunlight • avoid things t...
Page 8
1. Switch off the handset within the new reception range of the repeater but outside the reception range of the telephone base station, and then switch it back on again. 2. To confirm the handset is working with the repeater, press the talk button on the handset whilst next to the repeater. You shou...
Page 9
Help the repeater led continues to flash on and off after the registration process has been completed • the registration process was not successful. You will have to repeat the registration process again with the telephone base station concerned. De-register the repeater, see page 9 and register it ...
Page 10
The repeater will not register • reset the repeater as described on page 9. Cannot make or receive calls when in the repeater reception range • there is no power to the repeater. Check that the power adaptor cable is plugged into the repeater, the power adaptor is plugged into the mains socket and t...
Page 11
General information safety general • only use the power supply included with the product. Using an unauthorized power supply will invalidate your guarantee and may damage the product. • do not open the repeater. This could expose you to high voltages or other risks. Contact the qualitel dect repeate...
Page 12
• do not use the qualitel dect repeater and handsets in damp, humid conditions such as bathrooms. Do not expose any of the equipment or batteries to fire or water. Product disposal instructions the symbol shown here and on the product means that the product is classed as electrical or electronic equ...
Page 13
The conditions of this guarantee are: • the guarantee shall only apply to defects that occur within the 6 month guarantee period. • proof of purchase is required. • the equipment is returned to qualitel or its agent as instructed. • this guarantee does not cover any faults or defects caused by accid...