User's manual quality commercial machines corporation copyright © 2001-2007 quality commercial machines corporation qcm desktop cutter for qcm-8200m and qcm-8700m.
Introduction congratulations on your selection of a qcm desktop cutter. We are certain you will be pleased with the purchase of this fine machine. Please read this manual carefully before putting the machine into operation. Keep this manual handy for future reference. It is considered a permanent pa...
Safety precautions when operating this machine the following safety precautions must be observed. ● this machine is designed for single person operation only. No more than one person is allowed to operate the machine at a time. ● under no circumstances should children be allowed to operate the machi...
Caution: after each cutting operation, always make sure to lift the cutting bar lever ծ back to the up position until the blade safety lock կ is engaged. 7. Release the clamp շ by rotating the clamp wheel ն counter-clockwise. Remove the paper stack from the machine. Maintenance this machine may only...
Figure 4 1. Locate the necessary tools. You need one blade holder ց䎃 (supplied with the machine) and one #2 philips screwdriver. 2. Place the machine on a flat, stable surface located in a traffic-free area and face the blade carrier ս䎃 side towards you. Fold down the support extender ջ as shown in ...
— 6 — 7. Rotate or turn the cutting stick to an unused surface or side. Insert the cutting stick back to its slot underneath the blade. Make sure the stick is well seated. 8. Raise the front end of the base as shown in figure 5. Place the two cutting stick holding screws փ䎃 back in place. Once the s...
