Quality Craft M630-44FGO Instruction Manual

Summary of M630-44FGO

  • Page 1

    1 electric fireplace heater model: m630-44fgo important: please note: when you open the carton, carefully check the unit and make sure there is no damage. If you have any problems with the unit, with how the various functions work, or have damaged or missing parts please call 1-800-459-4409 (monday ...

  • Page 2

    2 parts list: fireplace insert..................................................................................................... 1 a) top panel ........................................................................................................ 1 b) base panel ...................................

  • Page 3

    3 step 1: attach 14 plastic connector [p] to panels c, e, f, g and h as shown in fig. A (2 pcs kd screws for each plastic connector ). Attach wood connector [j] to panel c with 4 kd screws. Fig. A back step 2: attach panel e to panel g with 3 kd screws. Attach panel f to panel h with 3 kd screws. Se...

  • Page 4

    4 step 5: attach panel c to panel e and f with 4 kd screws. See fig. E. Fig. E back step 6: attach top panel [a] to the unit as shown in fig. F with 4 kd screws. Fig. F back step 7: attach 2 large “l” bracket [k] to panel d with 2 medium kd screws. See fig. G. Fig. G back step 8: foam tape (z1) has ...

  • Page 5

    5 step 11: attach fireplace insert to the unit in fig. J with 4 medium kd screws on the top side of the insert. Attach the bottom sides of insert to the large “l” bracket with 2 small screws, 2 washers and 2 nuts. Fig. J back step 12: tighten all kd screws. Step 13: move assembled unit to desired lo...

  • Page 6

    6 larger screw larger screw bulb repair set touch-up repair paint paint directly on the mantel unit if necessary. Repairs if any problems are found with the original parts during mantel assembly – such as if the panels cannot be installed with the plastic connector – try to solve by one of the follo...

  • Page 7

    7 option 2: use the small l-brackets and screws. 1. Place the small l-bracket to the unit and mark the drill holes on the mantel, as shown in fig. E. Fig. E 2. Drill the holes with diameter 1/16 inches (2 mm) and depth 5/16 inches (8 mm) on the mantel. Each small l-bracket needs 4 holes. See fig. F....