Quality Craft Weaver Nickel Plate Road L1a Owner's Manual

Summary of Weaver Nickel Plate Road L1a

  • Page 1

    Nickel plate road l1a & l1b 4-6-4 steam locomotive owner's manual (2-rail & 3-rail models) po box 231 ~ 315 point township drive ~ northumberland, pa 17857 phone: 570-473-9434 fax: 570-473-3293 web site: www.Weavermodels.Com ~ e-mail: customerservice@weavermodels.Com.

  • Page 2

    Lubrication points figure 1 lubrication points thank you for purchasing this weaver nickel plate road 4-6-4 steam locomotive. Our 1/4" scale brass reproduction is highly detailed and designed for years of operation on your o gauge or o scale pike. Weaver steam locomotives are completely compatible w...

  • Page 3

    Greasing points figure 2 adding smoke fluid to your smoke unit the tas fan driven smoke unit is capable of holding up to 40 drops of fluid. Before running the locomotive be sure to add at least 20 drops of fluid to prime the unit. While running without fluid will not damage the smoke unit it is advi...

  • Page 4

    The e-unit in your locomotive alternates between three states: forward, neutral, and reverse. You may deactivate the operation of the e- unit by moving the "full - signal" switch to the "signal" position. This will put your locomotive in a forward lock out operating state. This will allow your engin...

  • Page 5

    Cab-1 remote controller® numeric keypad commands when you press the aux1 on cab-1 remote controller®, you turn the numeric keypad into 10 command buttons. The keypad lets you control extra command features (until you press any top row button). 0 stops and resets the steam locomotive to forward. Whis...

  • Page 6

    Reprogramming lcru circuit boards to restore features due to the inevitable derailments, static and the nature of electricity, it is possible that your lcru could someday lose its setup program. The symptoms of this condition would be unresponsiveness in command mode. This can easily be remedied by ...