Quality Water Treatment Fleck 5600 SXT Installation Instructions Manual - page 14
Page 14 of 14
Copyright © 2009 Quality Water Treatment, All right reserved.
rev. 10.29.09
www.qualitywatertreatment.com
Your 5600SXT Water Softener System is now programmed and ready for operation.
Filling your water softener with water and purging air from it:
Turn all faucets off outside
and in home. Slowly open bypass valve and let the mineral tank fill with water. When water
stops running go to the nearest treated faucet to the Water Softener, unscrew aerator screen
if applicable and turn cold water on slowly, this will bleed the air from the tank, let the water
run until it clears. If you sized your water softener using our recommendation then you will go
through salt or potassium chloride slowly. Add five gallons of water to brine tank. Add three
40 to 50 pound bags of extra course, pelt salt or potassium chloride to brine tank. The resin is
already charged so initial regeneration is not required.
Installation and set up is now complete. Congratulations! Please fill free to email some pictures
of you new installation and a letter we will post it on our site for other customers to view. As
always we appreciate your business!