QualityCraft MW914T-35BK Manual - page 2
2
PArtS liSt
Fireplace ............................................................................................................... 1
A) Mounting bracket ............................................................................................. 1
B) Mounting screws ............................................................................................. 3
C) Wall anchors.................................................................................................... 3
D) Washers .......................................................................................................... 3
TOOLS REQUIRED: LEVEL, ELECTRIC DRILL, DRILL BITS 5/16 IN (8 MM), PHILLIPS SCREWDRIVER, HAMMER,
SAFETY GOGGLES AND GLOVES.
iNStAllAtiON
Step 1: Select the wall location where you want to hang your electric fireplace heater.
Measure the area where the mounting bracket will be installed. Using the
level, draw a guide line. Mark on the line where you will drill your holes for the
mounting screws. Use the guide line as the center line to ensure your fireplace
will be mounted straight and level. See Fig. A.
fig. A
Step 2: Drill 3 holes 5/16 in (8 mm) on the marked locations. For holes that do not hit
studs, use the supplied wall anchors (C). Install the wall anchors into the holes
and gently tap them into place with a hammer, until the flange of the wall anchor
is flush with the wall surface. See Fig. B.
fig. B
Step 3: Secure the mounting bracket (A) to the wall with 3 mounting screws (B) and
washers (D). See Fig. C.
fig. C
Step 4: Mount the fireplace to the mounting bracket. The extruded flange on the back of
the fireplace shall be fully inserted into the mounting bracket. See Fig. D.
fig. D
OPErAtiON
NOTe:
The electric fireplace heater may emit a slight harmless odor when first turned on.
This is caused by activating the internal heater components for the first time and should
not occur again.
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 watts. Once the fireplace unit
has been properly connected to a grounded electrical outlet, it is ready to operate.
OPErAtiON BY tHE cONtrOl PANEl
the controls are located on the top of the fireplace unit.
O/I:
Press this button for main power. The indicator light will turn on. See below for other
control switches.
: Standby button. Press this button once to turn on the fireplace. Press again to turn
off all functions below.
:
Press this button once for flame effect. The unit will be beep and the indicator light
will be ON. The bulbs for flame effect will turn ON. To adjust the flame intensity,
hold down the button - the flame optics will go higher or lower. Once you have
found the desired setting, release the button. Pressing the button again will stop
the flame effect.
750W:
For low heat function - Press this button while the 0/I and standby switches are
in the on position for low heat. The indicator light will turn on.
1500W:
For high heat function - Press this button while the 0/I, standby and 750W
switches are in the on position for high heat. The indicator light will turn on.
When the heater reaches to the desired temperature, the heater and 750W/1500W
indicator light will turn off but the fan still keeps working with air flow.
NOte:
When the 0/I or standby switch is turned OFF, all other heater functions will stop
even though the switches may be in the ON position.